Basic Operation
Laser Pointer Function
This remote control emits a laser beam from the laser light window. Press the LASER button to activate the laser pointer. The signal emission indicator lights red and the red laser beam is emitted. If the LASER button is pressed for more than one minute or if it is released, the laser light goes off.
The laser emitted is a Class II laser. Do not look into the laser light window or point the laser beam at yourself or other people. The following is the caution label for the laser beam.
CAUTION: Use of controls, adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. Never look directly into the laser light window while a laser is emitted, otherwise eye damage may result.
The caution label is put on the remote control.
Signal Emission Indicator
Laser Light Window 
Pointer Function
You can move the Spotlight or Pointer of the projector with the remote control to emphasize a part of the projected image.
1 | Press and hold the MENU and NO SHOW buttons for |
| more than 10 seconds to activate the Pointer function. |
| (The Laser pointer has switched to the Pointer function.) |
2 | Press the LASER button on the remote control |
| pointing toward the projector. The Spotlight or Pointer |
| is displayed on the screen with the LASER button |
| lighting green. Then move the Spotlight or Pointer with |
| the PRESENTATION POINTER button. If the LASER |
| button does not light green and continues to emit a |
| laser beam, try the abovementioned procedure until the |
| LASER button lights green. |
3 | To clear the Spotlight or Pointer out the screen, press |
| the LASER button pointing toward the projector and see |
if the LASER button lighting is turned off.
To switch to the Laser pointer again, press and hold the NO SHOW and MENU buttons for more than 10 seconds or slide the
When you reset the Pointer function, the remote control code will be reset, as well.
Spotlight | Pointer |
PRESENTATION POINTER button
MENU button
Press and hold the MENU and NO SHOW buttons for more than 10 seconds.
NO SHOW button
RESET/ON/ALL OFF
Switch
LASER button
After the Laser pointer has switched to the Pointer, use the LASER button as the Pointer function
✔Note:
•You can choose the size of Spotlight (Large/Middle/ Small) and the pattern of Pointer (Arrow/Finger/Dot) in the Setting Menu. See “Pointer” on page 49.
32