Intel PCM-6896 manual Copyright Notice, Acknowledgments

Page 2

Copyright Notice

This document is copyrighted, 2001. All rights are reserved. The original manufacturer reserves the right to make improvements to the products described in this manual at any time without notice.

No part of this manual may be reproduced, copied, translated or transmitted in any form or by any means without the prior written permission of the original manufacturer. Information provided in this manual is intended to be accurate and reliable. However, the original manufacturer assumes no responsibility for its use, nor for any infringements upon the rights of third parties which may result from its use.

Acknowledgments

VIA is a trademark of VIA Technology, Inc.

AMD is a trademark of Advanced Micro Devices, Inc. Award is a trademark of Award Software International, Inc. Cyrix is a trademark of Cyrix Corporation.

IBM, PC/AT, PS/2 and VGA are trademarks of International Business Machines Corporation.

Intel and Pentium are trademarks of Intel Corporation.

Microsoft Windows ® is a registered trademark of Microsoft Corp. SMC is a trademark of Standard Microsystems Corporation.

RTL is a trademark of Realtek Semi-Conductor Co., Ltd. C&T is a trademark of Chips and Technologies, Inc.

UMC is a trademark of United Microelectronics Corporation.

All other product names or trademarks are properties of their respective owners.

Part No. 2087689604 5th Edition

A1.0 Printed in Taiwan

March 2001

Image 2
Contents PCM-6896 Copyright Notice AcknowledgmentsPacking List FCC StatementAaeon Customer Services Message to the CustomerProduct Warranty Dear Customer Contents AwardBIOSetup Driver Installation General Information Introduction Features Specifications Page Audio Interface Chipset 815E SDD Interface Board Layout Board Dimensions Installation Safety precautions Removing the CPUInstalling a CPU Setting jumpers Open ClosedInstalling Dram DIMMs System MemoryLocation of Jumpers & Connectors List of Jumpers JumpersList of Connectors ConnectorsClear Cmos Selection JP1 JP2 & JP3 For COM3 & COM4 Selec- tion PC/104 Plus Voltage Select JP6 Front Panel Connectors JP5Speaker Out and Line out JP4 RS-232/422/485 COM 2 JP8, JP7 CPU/SDRAM Speed Select JP9 DiskOnChip socket DiskOnChip DOC 2000 Installation Configure DOC as a boot deviceDiskOnChip Address Selection JP10 CPU Fan Power Connector CN1 USB Connector CN5 & CN6 IDE Hard Drive Connectors CN7 Primary IDE Hard Drive Connector CN7IDE Hard Drive Connector CN7 IDE Hard Drive Connector CN7IR Connector CN10 ATX Power Connector CN11Digital Visual Interface Connector CN12 Keyboard and Mouse Connector CN13 VGA Display Connector CN14 Audio Connector CN15 Base-Tx Ethernet Connector CN17 Floppy drive connector CN19 Connecting the floppy driveFloppy Drive Connector CN19 Digital I/O Connector CN20 Audio Out Connector 1 Watt CN22 Compact Flash Connector Compact Flash ConnectorAward Bios Setup Starting setup To Enter Setup Before Boot Press DEL KEYCase of Problems Getting helpSetup keys These keys helps you navigate in SetupAdvanced Chipset Features Standard Cmos FeaturesAdvanced Bios Features Power Management SetupLoad Optimized Defaults PnP/PCI ConfigurationLoad Fail-Safe Defaults Set Supervisor/User PasswordStandard Cmos Features Date and Time ConfigurationPage Drive a Drive B Base Memory Halt OnMemory Extended Memory Other MemoryAdvanced Bios Features Virus WarningCPU Internal Cache/External Cache Swap Floppy Drive Typematic Rate Chars/Sec- Sets the number Typematic Rate Setting- Key strokes repeat at aTypematic Dealy Msec- Sets the delay time OS Select For DRAM64MB-SelectHDD S.M.A.R.T Capability Report No FDD For WIN 95- Wheather reportSdram Cycle Time Tras/Trc Advanced Chipset Features Sdram CAS Latency TimeSdram RAS-to-CAS Delay CPU Latency Timer System Bios CacheableVideo Bios Cacheable Delayed TransactionDisplay Cache Frequency Paging Mode ControlAGP Graphics Aperture Size System Memory FrequencyRas# Precharge Timing RAS-to-CAS OverrideRas# Timing On-Chip Secondary PCI IDE Integrated PeripheralsOn-Chip Primary PCI IDE IDE Primary/Secondary Master/Slave PIOKB Power on Password IDE HDD Block ModePower on Function USB ControllerUART2 Duplex Mode Hot Key Power OnUart Mode Select Onboard FDC ControllerOnboard Serial Ports 1, 2,3,4 Parallel Port ModeECP Mode Use DMA Onboard Parallel PortWatch Dog Timer Acpi Function Power Management SetupPower Management Video Off Method Video Off In Suspend Suspend ModeHDD Power Down Suspend TypeReload Global Timer Events Power On By RingResume By Alarm Reset Configuration Data PnP/PCI ConfigurationsPnP OS Installed Resources Controlled ByShutdown Temperature PC Health StatusAuto Detect DIMM/PCI CLK Clock By Slight AdjustFrequency/Voltage Control Spread SpectrumLoad Fail-Safe Defaults Load Optimized Default Load Optimized DefaultSet Supervisor Password Enter PasswordSet User Password Save to Cmos and Exit Save to Cmos and ExitQuit without Saving Drivers Installation Installing Drivers Installing Chipset Driver for Windows 95/98 Installing Ultra ATA Storage Driver for Windows 95/98 Installing LAN for Windows 95/98 ==Select the Optional Search for best Lan driverInstalling VGA for Windows 95/98 Installing Audio for Windows 95/98 Installing Security Driver for Windows NT Please perform this procedure firstInstalling Ultra ATA Storage Driver for Windows NT Installing VGA for Windows NT Installing Audio for Windows NT Installing LAN for Windows NT ==Intel Pro Adapter will appear ==Click on OKInstalling VGA for Windows Installing Audio for Windows Installing LAN for Windows