Intel PCM-6896 Hot Key Power On, Onboard FDC Controller, Uart Mode Select, UART2 Duplex Mode

Hot Key Power On

Simply pressing on the preselected keyboard key the system will power on.

Onboard FDC Controller

Select Enabled if your system has a floppy disk controller (FDC) installed on the system board and you wish to use it. If you install an add-in FDC or the system has no floppy drive, select Disabled in this field.

UART Mode Select

Select an operating mode for the second serial port:

Normal	RS-232C serial port
Standard	RS-232C serial port
IrDA 1.0	Infrared port compliant with IrDA 1.0
	specification
IrDA SIR	IrDA-compliant serial infrared port
IrDA MIR	1 MB/sec infrared port
IrDA FIR	Fast infrared standard
FIR	Fast infrared standard
MIR 0.57M	0.57-MB/sec infrared port
MIR 1.15M	1.15-MB/sec infrared port
Sharp IR	4-MB/sec data transmission
HPSIR	IrDA-compliant serial infrared prot
ASK IR	Amplitude shift keyed infrared port

UART2 Duplex Mode

In an infrated port mode, this field appears. Full-duplex mode permits simultaneous two-direction transmission. Half-duplex mode permits transmission in one direction only at a time. Select the value required by the IR device connected to the IR port.