C.1 DiskOnChip® 2000 Quick Installation Guide
C.1.1 DiskOnChip 2000 installation instructions
1.Make sure the target platform is powered OFF.
2.Plug the DiskOnChip® 2000 device into its socket. Verify the direction is correct (pin 1 of the DiskOnChip® 2000 is aligned with pin 1 of the socket).
3.Power up the system.
4.During power up you may observe the messages displayed by the DiskOnChip® 2000 when its drivers are automatically loaded into the system's memory.
5.At this stage the DiskOnChip® 2000 can be accessed as any disk in the system.
6.If the DiskOnChip® 2000 is the only disk in the system, it will appear as the first disk (drive C: in DOS).
7.If there are more disks besides the DiskOnChip 2000, the DiskOn- Chip® 2000 will appear by default as the last drive, unless it was programmed as the first drive. (Please refer to the DiskOnChip® 2000 utilities user manual.)
8.If you want the DiskOnChip® 2000 to be bootable:
a . Copy the operating system files into the DiskOnChip® by using the standard DOS command (for example: sys d:).
b . The DiskOnChip® should be the only disk in the systems or would be configured as the first disk in the system (c:) using the DUPDATE utility.
DUPDATE | D | /S: | DOC104.EXB /FIRST | (set as c:) |
DUPDATE | C | /S: | DOC104.EXB | (set as d:) |
60