Intel AX965Q user manual Memory Configurations, bit 64-bit

Page 25

User’s Manual

1.5.2Memory Configurations

You may install 256 MB, 512 MB, 1 GB and 2GB unbuffered nonECC DDR2 DIMMs into the DIMM sockets using the memory configurations in this section.

zYou may install varying memory sizes in Channel A and Channel B. The system maps the total size of the lower-sized channel for the dual-channel configuration. Any excess memory from the higher-sized channel is then mapped for single-channel operation.

zAlways install DIMMs with the same CAS latency. For optimum compatibility, it is recommended that you obtain memory modules from the same vendor.

zDue to chipset resource allocation, the system may detect less than 4 GB system memory when you installed four 1 GB DDR2 memory modules. This limitation appears on Windows® XP

32-bit operation system which does not support Physical Address Extension (PAE).

zIf you install Windows® XP 32-bit operation system, a total memory of less than 3GB is recommended.

zThis motherboard does not support memory modules made up of 128 Mb chips or double-sided x16 memory modules.

Notes on memory limitations

zDue to chipset limitation, this motherboard can only support up to 8 GB on the operating systems listed below. You may install a maximum of 2 GB DIMMs on each slot, but only DDR2-533 and DDR2-667 2 GB density modules are available for this configuration.

32-bit

 

64-bit

Windows 2000 Advanced Server

 

Windows XP Professional x64 Ed.

 

 

 

zSome old-version DDR2-800/667 DIMMs may not match Intel®’s OnDieTermination (ODT) requirement and will automatically downgrade to run at DDR2-533. If this happens, contact your memory vendor to check the ODT value.

zDue to chipset limitation, DDR2-800 with CL=4 will be downgraded to run at DDR2-667 by default setting. If you want to operate with lower latency, adjust the memory timing manually.

zDue to chipset limitation, DDR2-667 with CL=3 will be downgraded to run at DDR2-533 by default setting. If you want to operate with lower latency, adjust the memory timing manually.

zThe total memory may has 8MB reduction under Single Channel mode, and 16MB reduction under Dual Channel mode because the address space is reserved for the Intel® vPro™ Technology and the Intel® Quiet System Technology.

ATX Main board 25

Image 25
Contents Ver AX965Q User’s ManualContents User’s Manual Safety Information Technical Support Packing List Revision History Specifications Summary Hmdi Block Diagram Product1 introduction Before you Proceed Production IntroductionMotherboard Overview Placement DirectionScrew Holes Motherboard Layout Label Function Layout Content ListInternal Connector Central Processing Unit CPU Installing the CPU User’s Manual Installing the CPU Heatsink and Fan User’s Manual Uninstalling the CPU Heatsink and Fan User’s Manual Dimm Sockets Location System Memory32-bit 64-bit Memory ConfigurationsSize Vender Chip. No Dimm support Qualified Vendors Lists QVL - DDR2-800MHz CapabilityQualified Vendors Lists QVL - DDR2-667MHz Capability AM4B5708GQJS7E AU512E667C5KBGC Kingston 5YDIID9GCT Qualified Vendors Lists QVL - DDR2-553MHz CapabilityInstalling a Dimm Removing a Dimm Configuring an Expansion Card Installing an Expansion CardExpansion Slots IRQ Standard Interrupt AssignmentsPCI Express X16 Slot PCI SlotsPCI Express X4 Slot Clear RTC RAM Clrtc JumpersKeyboard Power Kbpwr Rear Panel Connectors ConnectorsHeadset Port Channel PS/2 KB connector This port is for a PS/2 keyboard Internal Connectors Front Panel Audio Connector Aafp Important notes on the Motherboard Power Requirements ATX Power Connector ATX12V, EatxpwrOptical Drive Audio Connector CD CPU & Chassis Fan Connector CPUFAN, CHAFAN1, CHAFAN2 ATX Main board User’s Manual System Power LED 2-pin Pwrled System Panel Connector FpanelATX Power Button/Soft-off Button 2-pin Pwrsw Reset Button 2-pin ResetSignal Signal Description Drive jumper setting Mode of devices Cable connector Primary Eide Connector PrieideDigital Audio Connector Spdifout Serial ATA RAID Connector SATARAID1 USB 2.0 Connector USB56, 78 Trusted Platform Module TPM Connector TPMSLOT1 Bios setup2 Bios Setup Program Bios SetupSub-menu List BoxBios Menu Screen IDE Device Setup Standard Cmos FeaturesDate Day, xx/xx/xxxx TimeVideo Driver A/BHalt On MemoryAdvanced Bios Features CPU Features CPU L1 & L2 & L3 Cache Quick Power On Self TestBoot Other Device First / Second / Third Boot DeviceBoot Up Floppy Seek Swap Floppy DriveTypematic Rate Setting Boot Up NumLock StatusGate A20 Option Typematic Rate Chars/SecMPS Version Control for OS Apic ModeOS Select for Dram 64MB Small Logo EPA ShowSystem Bios Cacheable Advanced Chipset FeaturesMemory Hole at 15M-16M PCI Express Root Port Function 3.4 PEG/Onchip VGA Control Dvmt ModeOn-Chip Frame Buffer Size DVMT/FIXED Memory SizeIntegrated Peripherals OnChip IDE Device Super I/O Device Watch Dog Timer Select USB Device Setting Run Vgabios if S3 Resume Power Management SetupAcpi Function Acpi Suspend TypeSuspend Mode Power ManagementVideo Off Method Video Off In SuspendPower On by Ring HDD Power DownResume by Alarm Soft-off by PWR-BTTNRest Configuration Data 6 PnP/PCI Configurations Init Display FirstResource Controlled By Maximum Payload Size CPU Clock Ratio Frequency/Voltage ControlAuto Detect PCI Clk Spread SpectrumLoad Fail-Safe Defaults Load Optimized Defaults Please Confirm Your Password Set Supervisor/User PasswordSave and Exit Setup Exit Without Saving