Page 17
This motherboard provides an AGP Slot, support the 4X/8X AGP VGA card.
2x notch 4x notch
AGP SLOT
2-6 Connectors and pin headers
2-6-1 Connectors
(1) Power Connector (20-pin block) : ATXPWR
ATX Power Supply connector. This is a new defined 20-pins connector that usually comes with ATX case. The ATX Power Supply allows to use soft power on momentary switch that connect from the front panel switch to 2-pins Power On jumper pole on the motherboard. When the power switch on the back of the ATX power supply turns on, the full power will not come into the system board until the front panel switch is momentarily pressed. Press this switch again will turn off the power to the system board.
Pin 1
PIN | ROW2 | ROW1 |
1 | 3.3V | 3.3V |
2 | -12V | 3.3V |
3 | GND | GND |
4 | Soft Power On | 5V |
5 | GND | GND |
6 | GND | 5V |
7 | GND | GND |
8 | -5V | Power OK |
9 | +5V | +5V (for Soft Logic) |
10 | +5V | +12V |
(2) ATX 12V Power Connector (4-pin block) : ATX12V
This is a new defined 4-pins connector that usually comes with ATX Power Supply. The ATX Power Supply which fully support Pentium 4 processor must including this connector for support extra 12V voltage to maintain system power consumption. Without this connector might cause system unstable because the power supply can not provide sufficient current for system.
12
