Intel VIA PT800, PT800DBP, PT800DBZ, VIA 8237 user manual Wake up Events

Video Off Method

This determines the manner in which the monitor is blanked.

DPMS (default)	Initial display power management signaling.
Blank Screen	This option only writes blanks to the video buffer.
V/H SYNC+Blank	This selection will cause the system to turn off the vertical and
	horizontal synchronization ports and write blanks to the video buffer.
Modem Use IRQ

This determines the IRQ in which the MODEM can use.

The settings are: 3, 4, 5, 7, 9, 10, 11, NA.

Power Button Function

Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off state. The settings are: Delay 4 Sec, Instant-Off.

State After Power Failure

This item allows the system power ON/OFF automatic when power loss and recovery again, you can choose Auto for recovery pre-state, or always ON/OFF after power recovery.

Wake Up Events

Please refer to section 3-8-1

3-8-1 Wake up Events

CMOS Setup Utility – Copyright(C) 1984-2003 Award Software

Wake Up Events

VGA		OFF	Item Help
LPT & COM		LPT/COM
HDD & FDD	ON
PCI Master	OFF		Menu Level >>
Wake-Up on Ring/LAN	Disabled
Wake-Up on PCI PME	Disabled
Wake-Up on RTC Alarm	Disabled
x Date of Month Alarm	0
x Time (hh:mm:ss) Alarm	0 : 0 : 0
> IRQs Activities	Press Enter

↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help

F5:Previous Values F6:Optimized Defaults F7:Standard Defaults

Wake Up On Ring/PME

During Disabled, the system will ignore any incoming call from the modem. During Enabled, the system will boot up if there’s an incoming call from the modem.

34