Connectors
Floppy Disk Connector: FDC
This mainboard provides a standard floppy disk connector (FDC) that supports 360K, 720K, 1.2M, 1.44M and 2.88M floppy diskettes. This connector supports the floppy drive ribbon cables provided in the packaging.
Hard Disk Connectors: IDE1-2/ SATA1-2
This mainboard has a
IDE1 (Primary IDE Connector)
You can connect up to two hard drives to IDE1. If you attach two drives, you must use a ribbon cable with three connectors. You must also configure one drive as the master and one drive as the slave, using the jumpers located on each drive.
IDE2 (Secondary IDE Connector)
The IDE2 controller can also support a Master and a Slave drive. The configuration is similar to IDE1. The second drive on this controller must be set to slave mode.
SATA1/ SATA2
The SATA connectors support Serial ATA 150 and SATA RAID 0 mode. The connectors only can connect one serial ATA hard disk device each.
| 21 | BIOS | LAN CHIP | ALC 65 0 |
|
|
|
|
| 1 |
| W83627HF | Winbond |
|
|
| 1 |
|
|
| 1 |
|
|
| 21 |
|
|
|
|
|
|
|
|
|
|
| 82865P | Intel | So cket 478 |
| 21 |
|
|
|
|
| 1 |
| 910 |
| Intel ICH 5 |
|
|
|
|
| 1 | 1 |
|
|
|
|
|
FDC | 1 |
|
|
|
|
| |
1 | 2 |
|
|
|
|
| |
|
|
| 1 |
|
|
|
|
| 9 | 10 |
|
|
|
|
|
SATA1 
SATA2
IDE2 
IDE1
13