9)SATAII0/1/2/3 (SATA 3Gb/s Connectors, Controlled by nVIDIA® nForce 650i SLI)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The nVIDIA® nForce 650i SLI controller supports RAID 0, RAID 1, RAID 5 and RAID 0+1. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array.
|
|
|
|
| Pin No. | Definition |
| SATAII1 |
| SATAII3 | 1 | GND | |
7 | 1 | 7 | 1 |
| 2 | TXP |
|
|
|
|
| 3 | TXN |
|
|
|
|
| 4 | GND |
7 | 1 | 7 | 1 |
| 5 | RXN |
| 6 | RXP | ||||
| SATAII0 |
| SATAII2 | |||
|
|
|
|
| 7 | GND |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Please connect the
SATA3Gb/s cable to your SATAhard drive.
•A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard
drives are to be used, the total number of hard drives must be an even number.
•A RAID 5 configuration requires at least three hard drives. (The total number of hard drives does not have to be an even number.)
•A RAID 0+1 configuration requires at least four hard drives and the total number of hard drives must be an even number.
- 28 - |