Intel GA-N650SLI-DS4L user manual Drive a, Floppy 3 Mode Support, Halt on, Memory

Page 40

The following fields display your hard drive specifications. If you wish to enter the parameters manually, refer to the information on the hard drive.

Capacity

Approximate capacity of the currently installed hard drive.

Cylinder

Number of cylinders.

Head

Number of heads.

Precomp

Write precompensation cylinder.

Landing Zone

Landing zone.

Sector

Number of sectors.

Drive A

Allows you to selects the type of floppy disk drive installed in your system. If you do not install a floppy disk drive, set this item to None. Options are: None, 360K/5.25", 1.2M/5.25", 720K/3.5", 1.44M/3.5", 2.88M/3.5".

Floppy 3 Mode Support

Allows you to specify whether the installed floppy disk drive is 3-mode floppy disk drive, a Japanese standard floppy disk drive. Options are: Disabled (default), Drive A.

Halt on

Allows you to determine whether the system will stop for an error during the POST.

No Errors

The system boot will not stop for any error.

All Errors

Whenever the BIOS detects a non-fatal error the system boot will stop.

All, But Keyboard

The system boot will not stop for a keyboard error but stop for all other

 

errors. (Default)

All, But Diskette

The system boot will not stop for a floppy disk drive error but stop for all

 

other errors.

All, But Disk/Key

The system boot will not stop for a keyboard or a floppy disk drive error but

 

it will stop for all other errors.

Memory

These fields are read-only and are determined by the BIOS POST.

Base Memory Also called conventional memory. Typically, 640 KB will be reserved for the MS-DOS operating system.

Extended Memory The amount of extended memory.

GA-N650SLI-DS4L Motherboard

- 40 -

Image 40
Contents GA-N650SLI-DS4L Motherboard Copyright DisclaimerDocumentation Classifications Identifying Your Motherboard RevisionTable of Contents Regulatory Statements Box Contents PCIE162 GA-N650SLI-DS4L Block Diagram Hardware Installation Installation PrecautionsProduct Specifications CPUPage Š 1 x 4 Mbit flash Installing the CPU and CPU Cooler Installing the CPUCPU Socket Lever Installing the CPU Cooler Installing the Memory Dual Channel Memory ConfigurationInstalling a Memory Installing an Expansion Card Setup of an SLI Scalable Link Interface Configuration Before You BeginSetting the SLI Configuration Jumpers Connecting Two Graphics CardsConfiguring the Graphics Card Driver Back Panel Connectors Center/Subwoofer Speaker Out Jack Orange Rear Speaker Out Jack BlackSide Speaker Out Jack Gray Line In Jack BlueInternal Connectors SATAII0/1/2/3GND 5 CPUFAN/SYSFAN/PWRFAN Fan Headers Nbfan North Bridge Fan HeaderFDD Floppy Disk Drive Connector IDE1 IDE ConnectorTXP Pwrled System Power LED Header BAT BatteryFpanel Front Panel Header Cdin CD In Connector Faudio Front Panel Audio HeaderSpdifo S/PDIF Out Header Spdifin S/PDIF In HeaderFUSB1/FUSB2 USB Headers, Yellow 18 CI1 Chassis Intrusion HeaderClrcmos Clearing Cmos Jumper Bios Setup Startup Screen Logo Screen DefaultPost Screen Sample Bios Version D1 Bios Setup Program Function KeysMain Menu Main Menu Help„ Standard Cmos Features „ Advanced Bios Features„ Power Management Setup „ PnP/PCI ConfigurationsDate TimeIDE Channel 0 Master/Slave IDE Channel 2/3/4/5 MasterFloppy 3 Mode Support Drive aHalt on MemoryHard Disk Boot Priority First/Second/Third Boot DevicePassword Check HDD S.M.A.R.T. CapabilityLimit Cpuid Max. to 3 Note No-Execute Memory Protect NoteCPU Enhanced Halt C1E Note CPU Thermal Monitor 2 TM2 NoteSATA-II RAID function SATA-II 1 Primary RAIDSATA-II 1 Secondary RAID SATA-II 2 Primary RAIDIDE DMA transfer access Onboard LAN Boot ROMIDE Prefetch Mode SATA-II 2 Secondary RAIDSmart LAN LAN Cable Diagnostic Function When No LAN Cable Is AttachedWhen LAN Cable Is Functioning Normally When a Cable Problem OccursParallel Port Mode ECP Mode Use DMALegacy USB storage detect Onboard Serial PortModem Ring On PME Event Wake UpUSB Resume from Suspend Power-On by Alarm Power On By MousePower On By Keyboard KB Power on PasswordPCI 1 IRQ Assignment PnP/PCI ConfigurationsPCI 2 IRQ Assignment Reset Case Open Status Current System/CPU TemperatureCurrent CPU/SYSTEM/POWER FAN Speed RPM CPU Warning TemperatureCPU Smart FAN Control CPU Smart FAN ModeSystem Smart FAN Control System Clock Setting MB Intelligent TweakerM.I.TFSB-Memory Clock Mode FSB-Memory RatioCPU Host Frequency Mhz Actual CPU Clock MhzDDR2 Voltage Control NB/HT-Link VoltageFSB Voltage South Bridge VoltageLoad Fail-Safe Defaults Load Optimized DefaultsSupervisor Password User PasswordSave & Exit Setup Exit Without SavingGA-N650SLI-DS4L Motherboard Drivers Installation Installing Chipset DriversSoftware Applications Driver CD InformationHardware Information Contact UsGA-N650SLI-DS4L Motherboard Xpress Recovery2 System RequirementsInstallation and Configuration Installing Windows XP and Partitioning the Hard DrivePage Accessing Xpress Recovery2 Using the Backup Function in Xpress Recovery2Removing the Backup Using the Restore Function in Xpress Recovery2Exiting Xpress Recovery2 Bios Update Utilities Updating the Bios with the Q-Flash UtilityWhat is Q-FlashTM? What is @BIOSTM?Updating the Bios Page Updating the Bios with the @BIOS Utility Installing and Using @BIOSSave the Current Bios File Update the Bios Using the Internet Update FunctionUpdate the Bios without Using the Internet Update Function Click Update New BiosEasyTune EasyTune 5 Interface Button Information TableWindows Vista ReadyBoost PropertiesConfiguring Sata Hard Drives Configuring the Onboard Sata ControllerTo configure Sata hard drives, follow the steps below Installing Sata hard drives in your computerConfiguring Sata controller mode in Bios Setup Step Save changes and exit Bios SetupConfiguring RAID set in RAID Bios AppendixYES Nvidia Cd bootdrv Menu Making a Sata RAID Driver DisketteInstalling the Sata RAID Driver and Operating System ENTER=Select F3=Exit Enter= Continue R=Repair F3=Exit Configuring Audio Input and Output Configuring 2/4/5.1/7.1-Channel AudioConfiguring Speakers High Definition Audio HD AudioConfiguring AC97 Audio Configuring Sound EffectSound Effect tab Installing the S/PDIF In Cable Installing the S/PDIF In Cable OptionalPdif Pdif Out Configuring S/PDIF outConneting a S/PDIF out Cable Configuring Microphone Recording Appendix Recording the Sound Using the Sound RecorderPlaying the Sound Troubleshooting Frequently Asked QuestionsTroubleshooting Procedure StartEND Regulatory Notices Weee Symbol StatementOur Commitment to Preserving the Environment China Restriction of Hazardous Substances Table GA-N650SLI-DS4L Motherboard Appendix GA-N650SLI-DS4L Motherboard Contact Us Taiwan HeadquartersGigabyte Global Service System Poland Ukraine Romania Serbia & Montenegro