Hardware Specifications and Features
Hardware Specifications and Features | 3 |
This chapter covers all the hardware specifications associated with the IIR controller and its components. Section 3.5 covers optional RAID features that are supported by the RAID Software Suite. The accompanying Software Guide covers all implemented software features.
3.1IIR Controller Hardware Features
This section provides a summary of the key features, configuration options and support interface technology supported by the IIR controller.
Table 3-1. Hardware Architecture Features
Component | Feature | |
|
| |
I/O Microprocessor | The 80303 processor: 100MHz, RISC | |
|
| |
| The 80303 IOP supports up to 512 Mbytes of | |
| MHz ECC SDRAM operating at 66 MHz. It is backward | |
Cache Memory | compatible to support 64, 128, and 256 Mbit SDRAM | |
| technologies. Note: The SRCMRU is limited to 32MB of | |
| embedded memory. | |
|
| |
Flash Memory | 3.3v, 16Mbit (2 MB) flash memory chip is used to store | |
the RAID firmware | ||
| ||
|
| |
I/O interface (PCI) | ||
|
| |
PCI Transfer Rate | 528MB/second (burst) | |
|
| |
PCI Signaling | Capable of being used in a 5 volt or 3.3 volt slot. | |
|
|
Table 3-2. Electrical Specifications
Attribute | Measurements | |
|
| |
Voltage Requirements | +5, 3.3 Volts (all +/– 5% tolerance) | |
|
| |
Power Consumption | +5V @ 0.25 Amps = 1.25W | |
+3.3V @ 2.5 Amps = 8.25W | ||
| ||
|
|
Hardware Installation and User’s Guide | 17 |