Intel 273561-003 manual Flash Memory Programming

Page 25

Flash Memory Programming

2.Change your computer’s BIOS setting so that your system boots from the CD-ROM.

3.Use the RAID Software Suite CD-ROM to flash the firmware.

a.Boot the computer with the bootable RAID Software Suite CD-ROM that contains the version of the RAID firmware that you wish to recover.

b.At the ROM-DOS Startup menu, select the option, Flash Recovery Utility, and press <Enter>.

c.The Flash Recovery Utility detects any IIR controllers that are in reset mode and lists them in the order that they are found.

Note: Any IIR controllers that are not in reset mode will not be listed. If no controllers are listed, your controller may not be in reset mode. Shut down the system and start again with step 1 above. Refer to Figure A-1to set the jumper in reset mode.

d.Type a controller number to start the recovery process for the firmware on that controller. You do not need to press Enter after typing the number. You will see the messages shown below during a successful recovery. Each message provides a percent complete status while the action is in progress. The entire process may take several minutes.

Erasing flash memory Downloading data to flash memory Verifying flash content with input file Flash upload complete

SUCCESS: Operation completed successfully Download complete in <duration of flash recovery>

4.Reset the jumper to run mode.

a.Power off all system components and disconnect power cords.

b.Remove the system cover.

c.Remove the IIR controller from your system.

d.On Jumper block J1B1 move jumper from position 1-2 to position 2-3 (see Figure A-1). Reinstall the IIR controller in the RAIDIOS PCI slot in which it was previously installed. Reconnect the SCSI drives to the adapter card.

e.Replace the cover, reconnect all power cords and power up the system.

5.Change your computer’s system BIOS setting so that your system boots normally (not from the CD-ROM).

Note: A firmware recovery returns the controller to the default settings.

Hardware Installation and User’s Guide

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Srcmru Hardware Installation and User’s Guide Contents Tables Intended Audience Using the User Documentation SetCustomer Support Contact Information About This GuideDocument Formats Regulatory and Certification Information Product Safety ComplianceProduct Regulatory Compliance Product EMC ComplianceAustralia C-Tick Mark Culus Listing Marks CE Mark FCC Marking Class aCanada EMC Marking Class a Taiwan Bsmi Marking Class a Korea RRL MIC MarkJapan Vcci Marking Class a Electromagnetic Compatibility NoticesFCC Verification Statement USA CE Declaration of Conformity Europe Ices 003 CanadaVcci Japan Bsmi Taiwan About this Chapter Installation ProceduresComputer System Hardware Requirements IIR Controller Component Layout Installing the IIR ControllerScsi Termination Programming the Flash MemoryConfigurable I/O Controller Scsi Parameters Configurable Disk Drive Scsi ParametersConfigurable Disk Drive Scsi Parameters Configurable I/O Controller Scsi ParametersHardware Architecture Features IIR Controller Hardware FeaturesElectrical Specifications Operating System Support Environmental SpecificationsSupported Scsi Technology Supported Scsi Device Standards Supported Hard Drive TechnologyRAID Array Drive Roaming Optional Features RAID Controller Drive Maximum Limitations Srcmru Flash Memory Programming Firmware Update Procedure via Xrom StorConFigure A-1. Jumper Positions for Flash Update and Recovery Firmware Recovery Procedure via Flash Recovery Utility FRUFlash Memory Programming Flash Memory Programming Index
Top Page Image Contents