Konica Minolta C252 appendix Troubleshooting

6

		Troubleshooting
Symptom	Probable Cause	Action
The stapling position	The orientation setting is not cor-	Check the stapling position in the
is not as expected.	rect.	printer driver setup dialog box.
The hole punch func-	Hole punching cannot be speci-	Check each setting in the printer
tion cannot be speci-	fied if “Booklet”, “Transparency”,	driver.
fied.	“Thick2”, “Thick3”, or “Envelope”
	is selected.
	A punch kit must be installed on	Install the required optional finish-
	an optional finisher.	er and enable it using the printer
		driver.
The pages are not	Printed pages may be fed out	Check the orientation setting.
punched.	without being punched if the pa-
	per is loaded into the paper
	source with an incorrect orienta-
	tion.
The hole punch posi-	The orientation setting is not cor-	Check the punch position on the
tion is not as expect-	rect.	Layout tab of the printer driver
ed.		setup dialog box.
The form is not printed	Available computer memory	Simplify the form to reduce the
properly.	space is not sufficient.	data size.
The image is not print-	Available computer memory	Simplify the image to reduce the
ed properly.	space is not sufficient.	data size.
Paper is not fed from	Paper will not be fed from the	Load the paper source with paper
the specified paper	specified paper source if that pa-	of the appropriate size and orien-
source.	per source is loaded with paper of	tation.
	a different size or orientation.
The access number	To specify access numbers, a	Add a hard disk in the Option tab
cannot be specified.	hard disk must be added in the	of the printer driver.
	Option tab of the printer driver.

6-4 C252