Lenovo RD530, RD630, RD330 manual Configuration, Network

Page 26

Configuration

Table 6. Power control

Option	Comments

Power Status	Shows the current status of the power control (OFF or ON).

Power On System	Turns on the system when it is in the off state.

Power Off	Turns off the system when it is in the on state.
System

Power Cycle	Turns off, then reboots the system (cold boot).
System

Hard Reset	Restarts the system without turning it off (warm boot).
(Restart)

Configuration

The Configuration page is used to configure Network settings, user settings, updates, and so on.

Network

The Network page is used to configure the Network settings. It includes the following options:

•Automatic (Obtain an IP address automatically): Automatically obtain an IP address (use DHCP).

•Manual (Use the following IP addresses): Manually configure IP addresses.

Figure 16. Network settings

You can configure the Network settings by click ncsi0 item.

Table 7. Network settings

Option	Comments

MAC Address	The MAC address of the device (Read Only).

IPv4 Settings	If you want to configure the IP by IPv4 protocol, enable the IPv4 and then set the IP address.

IPv6 Settings	If you want to configure the IP by IPv6 protocol, enable the IPv6 and then set the IP address.

VLAN Settings	When you enable virtual LAN, you have to set the VLAN ID and Priority.

22ThinkServer Management Module User Guide

Image 26

Contents ThinkServer Management Module User Guide ThinkServer RD330, RD430, RD530, and RD630First Edition August Copyright Lenovo “Safety information” on pageAppendix B “Notices” on page Contents iiThinkServer Management Module User Guide Terminology Safety informationChapter 1. Introduction of the server chassis to provide ESD protection Security - open source SSL Compatible with IPMI 4ThinkServer Management Module User Guide Page 6ThinkServer Management Module User Guide Prestart Figure 1. Configuring IE ESC - setp 8ThinkServer Management Module User GuideFigure 2. Configuring IE ESC - setp Log-on Navigation Log-out 12ThinkServer Management Module User GuideMain window of the remote console Chapter 5. Remote console KVM operationStart the redirection console Menu bar of the remote consoleTools menu of the remote console Power menu of the remote consoleMacros menu of the remote console Properties Viewing propertiesViewing the System Event Log Server informationViewing sensor readings Platform Events Trap Settings Email Settings Event managementPlatform Events Serial Over LANSerial Over LAN Trap Settings SNMPEmail Settings SMTP Figure 9. Trap SettingsRemote control Remote managementFigure 13. Remote management launch Virtual mediaFigure 12. Remote management configuration Figure 14. Redirecting virtual device Power controlFigure 15. Power control Configuration NetworkUsers Network securitySecurity Figure 17. Network security settingsFigure 19. Users setting ServiceIPMI Figure 20. Service settingSession Figure 22. Session settings UpdateLDAP Figure 23. LDAP settingsUtilities Languages Figure 25. UtilitiesAppendix A. Frequently asked questions 30ThinkServer Management Module User Guide 1009 Think Place - Building One Morrisville, NC Appendix B. NoticesLenovo United States, Inc U.S.A Attention Lenovo Director of LicensingTrademarks 32ThinkServer Management Module User Guide