Lenovo 6436, 6438, 6437, 6435 manual Drives

Table 1. Features and specifications

Microprocessor:

One Intel® LGA 775 single core, dual core, or quad core, depending on the server model:

vSingle core: Celeron 440 or later

vDual core: Core 2 Duo E4600 or Xeon E3110, or later

vQuad core: Xeon 3300 series

Notes:

1.Use the Configuration/Setup Utility program to determine the size of the L2 cache, type and speed of the microprocessor, and speed of the front-side bus.

2.Intel Virtualization Technology (VT) is not available on the Celeron 440 or the Core 2 Duo E4600; however, these microprocessors can run paravirtualization.

Memory:

vMinimum: Two 512 MB DIMMs

vMaximum: 8 GB

vType: PC2-5300, 667 MHz, ECC, DDR II unbuffered SDRAM DIMMs

vSlots: Four dual inline

vSupports 512 MB, 1 GB, and 2 GB DIMMs

Drives:

Ultrabay Enhanced: CD or CD/DVD

Expansion bays:

One of the following configurations:

vTwo 3.5-inch slim-high bays for hard disk drives.

–Hot-swap models: Supports maximum of two serial-attached SCSI (SAS) drives or two serial ATA (SATA) drives.

–Simple-swap models: Supports maximum of two SATA drives

vFour 2.5-inch small form-factor (SFF) hot-swap bays for hard disk drives. Supports a maximum of four 2.5-inch SAS drives.

Expansion slots:

Two PCI Express x8 slots, one low-profile and one 3/4-length full height. Low-profile slot supports x4 electrical.

Video controller:

vATI ES1000 video on system board

v16 MB DDR II video memory

Power supply:

351 watt (110 or 220 V ac auto-sensing)

Size:

vHeight: 43 mm (1.75 inches, 1 U)

vDepth: 559 mm (22 inches)

vWidth: 440 mm (17.32 inches)

vMaximum weight: 12.7 kg (28 lb) depending on your configuration

Integrated functions:

vTwo Broadcom NetXtreme™ GB Ethernet controllers on the system board with Wake on LAN® support

vSerial port

vFour USB ports (two on front and two on rear of server)

vSystems-management port if an optional Remote Supervisor Adapter II SlimLine is installed

Hard disk controllers:

vSerial ATA (SATA) controller (simple-swap SATA models)

vSerial-attached SCSI (SAS) controller with integrated RAID (hot-swap SAS/SATA models) that supports RAID levels 0, 1, 1E

Environment:

vAir temperature:

–Server on: 10° to 35°C (50.0°

to 95.0°F); altitude: 0 to 914.4 m (3000 ft)

–Server on: 10° to 32°C (50.0°

to 89.6°F); altitude: 914.4 m (3000 ft) to 2133.6 m (7000 ft)

–Server off: 10° to 43°C (50.0° to 109.4°F); maximum altitude: 2133.6 m (7000 ft)

–Shipping: -40° to 60°C (-40° to 140°F); maximum altitude: 2133.6 m (7000 ft)

vHumidity:

–Server on: 8% to 80%

–Server off: 8% to 80%

Acoustical noise emissions:

vSound power, idling: 6.5 bel maximum

vSound power, operating: 6.5 bel maximum

Heat output:

Approximate heat output in British thermal units (Btu) per hour:

vMinimum configuration: 341 Btu per hour (100 watts)

vMaximum configuration: 1024 Btu per hour (300 watts)

Electrical input:

vSine-wave input (50 - 60 Hz) required

vInput voltage low range:

–Minimum: 100 V ac

–Maximum: 127 V ac

vInput voltage high range:

–Minimum: 200 V ac

–Maximum: 240 V ac

vApproximate input kilovolt-amperes (kVA):

–Minimum: 0.102 kVA

–Maximum: 0.55 kVA

Notes:

1.Power consumption and heat output vary depending on the number and type of optional features that are installed and the power-management optional features that are in use.

2.These levels were measured in controlled acoustical environments according to the procedures that are specified by the American National Standards Institute (ANSI) S12.10 and ISO 7779 and are reported in accordance with ISO 9296. Actual sound-pressure levels in a given location might exceed the average stated values because of room reflections and other nearby noise sources. The declared sound-power levels indicate an upper limit, below which a large number of computers will operate.

3.There is no keyboard connector or mouse connector on the server. You can connect a USB keyboard and USB mouse to the server by using the USB connectors.

4ThinkServer RS110 Types 6435, 6436, 6437, and 6438: Installation Guide