Lenovo T545 manual Operating System, Screen resolution

i If the monitor is in standby mode (STANDBY ON), it

may automatically turn off while you are waiting for it to warm up.

i The size and diversity of the dot pattern varies with the

screen resolution.

i Position the mouse pointer at the bottom center of the

screen. This allows AUTO SETUP to run properly

1.Turn on the monitor first; then the computer.

If the message CHECK SIGNAL CABLE is displayed, or if nothing is displayed check:

•that the video interface cable is not connected properly.

•the correct video adapter card is not installed.

2.Wait approximately 15 minutes, until the monitor warms up.

3.Drag the icon bar and tool bar, if they are displayed, to the bottom of the screen.

4.Insert the diskette labelled ‘IBM Monitor Installation Disk’ into the diskette drive.

5.Check the operating system installed on your computer and follow the instructions from the table below.

6.When the test pattern appears, press the OSD Enter button at the bottom of the monitor to display the initial OSD menu.

7.Use an Arrow button ( or ), to select the IMAGE SET-UP icon

and press the OSD Enter button to access the function.

8.Using an Arrow button ( or ), select AUTO and press the OSD Enter button . This activates the AUTO SETUP procedure, which will optimize the display settings with the provided test pattern. The image may be affected during this procedure and you may notice small changes to the test pattern.

To abort the AUTO SETUP function, press the ESC key.

9.When finished, the OSD main menu returns. Press the Exit button once to exit from the OSD.