ENGLISH
2.Lift the bottom of the cable cover (A) and pull it off.
A
B
C
3.Lay the monitor facedown on a cushion and remove the four screws holding the hinge mechanism on the monitor. Lift off the hinge and base assembly(B).
4.If you are installing an arm or
5.Squeeze the side of the rear cover (C) and pull it off.
6.Remove the signal cable and the power cord from the monitor by disconnecting the corresponding adapters.
7.Connect the signal cable and the power cord and ensure the positioning of the cables is as shown in the diagram.
8.Slide the rear cover(C) on rear panel of the monitor.
9.Put the hinge cover back on, fit the four screws to hold the hinge mechanism on rear panel of the monitor.
10.Slide the cable cover on the base assembly(B).
To obtain the correct cables and/or to get further instructions on installing them, call the IBM HELPCENTER at the above numbers or contact your dealer, retailer, or other IBM authorized Servicer.
23