Setting
On start | On start |
When this function is "On", the projector is automatically turned on just by connecting the AC power cord to a wall outlet.
✔Note:
•Be sure to turn the projector off properly (see "Turning Off the Projector" on page 19). If the projector is turned off in the incorrect sequence, the On start function does not operate properly.
Lamp control
This function allows you to change brightness of the | ||
screen. |
|
|
Normal . . | normal brightness | |
Auto . . . | brightness according with the | |
Eco | input | signal |
lower brightness reduces the lamp | ||
| power consumption and extends | |
| the lamp life. | |
Remote control | Remote control | |
This projector provides two different remote control codes: the
When operating the projector in "Code 2", both the projector and the remote control must be switched to "Code 2".
To change the code for the projector:
Select either "Code 1" or "Code 2" in this Setting Menu.
To change the code for the remote control:
Press and hold both the MENU and IMAGE buttons together for 10 seconds or more. After changing the code, make sure the remote control operates properly.
✔Note:
If the batteries are removed from the remote control for a long period of time, the remote control code will be reset.
Press and hold MENU and IMAGE buttons for more than 10 seconds.
48