| Maintenance and Cleaning |
Lamp Replacement |
|
When the life of the projection lamp of this projector | Top Control |
draws to an end, the LAMP REPLACE indicator emits |
|
a yellow light. If this indicator lights yellow, replace the |
|
lamp with a new one promptly. |
|
WARNING:
TURN OFF THE UV LAMP BEFORE OPENING THE LAMP COVER
This indicator is yellow when the life of the projection lamp draws to an end.
CAUTION | CAUTION |
Allow a projector to cool, for at least 45 minutes before you open the Lamp cover. The inside of the projector can become very hot.
For continued safety, replace with a lamp of the same type. Do not drop a lamp or touch a glass bulb! The glass can shatter and may cause injury.
Follow these steps to replace the lamp.
1 | Turn off the projector and disconnect the AC power |
| cord. Allow the projector to cool for at least 45 |
2 | minutes. |
Remove the screw with a screwdriver, and remove | |
3 | the lamp cover. |
Remove 2 screws of the lamp with a screwdriver | |
| and pull out the lamp upwards vertically by |
4 | grasping the handle. |
Replace the lamp with a new one and tighten the 2 | |
| screws back into position. Make sure that the lamp |
| is set properly. Replace the lamp cover and tighten |
| the screw. |
5 | Connect the AC power cord to the projector and |
6 | turn on the projector. |
Reset the lamp replacement counter.. | |
| See "Lamp Replacement Counter" on the next |
| page . |
Lamp Cover | Screw |
Lamp Handle
Screw | Screw |
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.
● Model No. of your projector | : |
● Replacement Lamp Type No. | : |
Service Parts No. | 610 334 9565 |
55