Sanyo 42LM5RTC, 42LM4RTC, 42LM4WPTC manual

Page 9

The mouse pointer will not respond to a touch until it has been enabled in the Output section of the Control Program. Details of this will follow later in this manual.

The Reset button loads fresh data from the touchscreen. This is used as a reference for detecting any new touches. This may be necessary if the touchscreen environment has been changed; for example, the touchscreen has been moved.

Image 9

Contents 42LM4WPTC 42LM5WPTC 42LM4RTC 42LM5RTC Interactive Touchscreen User GuideFor serial Interface Interactive Touchscreen User GuidePage TABLE OF CONTENTS ABOUT THIS MANUAL CARE AND CLEANING OF THE TOUCHSCREENCONTACT INFORMATION SHIPPING DAMAGE/UNPACKINGCOMPATIBILITY INTRODUCTIONINSTALLATION LOADING THE TOUCH DRIVER SOFTWARE ONTO PCDo not plug the touchscreen interface cable into your computer STARTING THE DRIVER CONTROL PROGRAM CONFIGURING THE COMMUNICATIONS PORTEXPLANATION OF THE STATUS SECTION Reasons why the driver does not see the touchscreen are usuallyPage ADJUSTING THE TOUCH SENSITIVITY LEVEL Automatic SetupManual Sensitivity Setup Page CALIBRATION To enable the touch function on the screen, tick the Enable check box SETTING THE TOUCH OUTPUT TO SUIT THE APPLICATION PROGRAM1. Fig 8 Click on file 2. Click on save to save the current settings You must now save the settingsTesting the Hardware with ‘Graph’ DIAGNOSTICS AND FREQUENTLY ASKED QUESTIONSWire Integrity Test Signal to Noise CheckMONITOR MODE DELAYED STARTING OF THE DRIVER OUTPUT USING EDGE ENHANCEMENTPROBLEMS WITH WINDOWS AUTOMATICALLY RUNNING THE DRIVER FROM START- UP FAULT FINDING GUIDESLOW TOUCH SCREEN RESPONSE WHEN USING POWER HUNGRY APPLICATIONS DRIVER DOES NOT SEE THE TOUCHSCREENTo set the priority settings permanently when the system restarts CHECK OR CHANGE THE VIRTUAL MEMORY SETTINGSDRIVER PRIORITY CHANGE @echo off start /high c\program files\TouchScreen\MA7Driver.exe