Sanyo POA-LN01 appendix Network configuration, Procedure of Connecting the monitor to the network

Page 13

Network configuration

[3] Network configuration

When you connect a monitor to a network, the network number of monitor must be the same as the network you intend to connect. You should configure monitorʼs network first. Make sure that the monitor is connected to the network correctly. To configure the network, use the computer. Refer to the chart below.

Procedure of Connecting the monitor to the network

Configure the network with computer		p.14
Temporarily set up the computer's	Please see further
	informatin on pages
network with the default network	14-19.
number of the PJ-Net Organizer.	Example of monitor's configuration

	IP Address : 192.168.0.5
	Subnet Mask : 255.255.255.0
Restart the Computer, if required	Default Gateway : (blank)
	DNS : (blank)
Using the web browser and login to	Please see further
the setting page of the PJ-Net	informatin on pages
Organizer by accessing the default	22-25.
IP address.	Default Network Address of the PJ-
	NetOrganizer
	IP Address : 192.168.0.2
	Subnet Mask : 255.255.255.0
	Default Gateway : 0.0.0.0
Change the network address you	DNS : 0.0.0.0

want to connect to the existing
network through the setting menu	Example of monitor's configuration
on the browser.	IP Address : 172.21.95.224
	Subnet Mask : 255.255.255.0
	Default Gateway :172.021.095.001
	DNS : 172.21.1.53

Restart the PJ-Net Organizer

Reset to the computer's original network configuration.

Completing the network configuration. Perform the basic setting and operation of the monitor by using the web browser. Please see chapter "2: Basic Setting and Operation" on page 21 for further information.

13

Image 13

Contents OWNERʼS Manual PJ-Net OrganizerCompliance PreparationFederal Communication Commission Notice TrademarkUse of this manual Expression/AbbreviationContents Web Management function FeaturesMail Alert function Recommended Operating Environment Installation Flow of installation InstallationInstallation p.10-12 Network configuration p.13-19LCD Monitor Name and function of each partMounting Up Down Position Position Connection of LAN cable Procedure of Connecting the monitor to the network Network configurationDNS Configure the network with the computerCompleting of installation Flash Player Windows Configure the network of computerWindows XP Installation Page Basic Setting and Operation Login the setting page of the monitor Basic Setting and OperationLogin Enter the IP addressDisplay of setting Password Setting Initial SettingsSetting the model ID Configure the networkMail Setting Mail SettingAdministrator Address Smtp Server*1Option Condition selection for sending alert message Mail Check and DeleteExamples Type and contents of alert mail LCD Information Setting Snmp Agent Snmp SettingTrap Send Setting Trap Trap Option Selection for sending alert message Trap Check and DeleteControlling the Monitor Check the status of monitor Controlling the MonitorStatus Child Lock Key Lock of Monitor Control the monitor PowerInput Wide ModeOther Make a memo Use other commandPage Serial Port Use Serial Port Use Specification and Setting of RS232C TerminalExample of Connection Example Power on C00 Command for controlling the monitorHow to set Network configuration on network board to default Appendix Examples of Connection AppendixDirect connection Meeting Room Gateway Router installed in the networkActive Script/JavaScript enable Web browser settingProxy setting Examples OS/Browsers Internet Explorer ActiveScript settingWindows XP Professional Using proxy server Proxy settingNot using proxy server Applicable monitor model Product specificationLAN port specification Port SpecificationPin modular connector RJ-45 MAC AddressPage Part No 333 5582 1AA6P1P5387-- Iffna