Sanyo PDG-DSU30 owner manual Remote Control Battery Installation, Remote Control Operating Range

Page 12

Introduction

Remote Control Battery Installation

1

Press firmly and slide

2

Install new battery into the

3

Put the cover

the battery cover off.

compartment.

back.

CR20253VOL

T

S

Remove the old Lithium coin cell and install new one (CR2025). Ensure that the side with a “+” is facing up.

3VOL

T

S

To ensure safe operation, please observe the following precautions :

Use CR2025 type battery.

Avoid contact with water or liquid.

Do not expose the remote control to moisture or heat.

Do not drop the remote control.

If the battery has leaked in the remote control, carefully wipe the case clean and install new battery.

Risk of an explosion if battery is replaced by an incorrect type.

Dispose of used battery according to the instructions.

Remote Control Operating Range

Point the remote control toward the projector (In- frared Remote Receiver) when pressing any button. Maximum operating range for the remote control is about 23.0’ (7m) and 30° in front of the projector.

23.0’ (7m)

Approx.15°

11

English

English

Image 12
Contents Model PDG-DSU30 Table of Contents Precautions Usage NoticeRear Do not Product Features IntroductionPackage Overview NotProduct Overview Connection Ports Computer IN/COMRemote Control ImageInput Remote Control Battery Installation Remote Control Operating RangeConnecting the Projector Connect to Computer/NotebookEnt accessories Connect to VideoPowering On/Off the Projector Powering On the ProjectorPowering Off the Projector Installation Adjusting the Projected Image Adjusting the Height of Projector ImageAdjusting the Projector Zoom and Focus Adjusting Projection Image SizeHow to operate On Screen DisplayImage Mode BrightnessContrast Sharpness SaturationTint Image Advanced GammaBrilliantColorTM Color TempReset Image Advanced ColorImage Advanced Input ColorAspect Ratio OverscanZoom Image ShiftKeystone Language LanguageMounting Volume Menu LocationMute Signal Fine SyncTotal Dots Position Horizontal PositionAdvanced LogoInput Search High AltitudeInformation Hide Background ColorPower Mode Direct Power OnAuto Power Off min Sleep Timer minLamp Settings Troubleshooting Problem No image appears on screenProblem Partial, scrolling or incorrectly displayed image Problem Image is unstable or flickering IBM=Problem Image is out of focus Problem The image is stretched when displaying 169 DVDProblem Image is too small or too large Problem Image is reversedProblem LED lighting message POWER-LEDProblem Message Reminders Lamp Replacing Procedure Replacing the lampOrder Replacement Lamp Specifications NTSC-M/NTSC-4.43/PAL-B, D, G, H, I/PAL-M/PAL-N/SECAMModes Resolution Frequency KHz Computer CompatibilityConfigurations of Terminals Terminal Analog RGB Mini D-sub 15 pinTerminal Mini DIN 3-pin Regulation & Safety Notices FCC noticeRemarque à l’intention des utilisateurs cana- diens Manufacturer and Address Authorized Representative and AddressSerial Control Interface OperationFunctional Execution Command FormatStatus Read Command Dimensions KW5A