Sanyo PDG-DSU30 owner manual Powering Off the Projector

Page 16

Installation

Powering Off the Projector

1.Press the “ON/STAND-BY” to turn off the projector lamp, you will see a message as below on the on-screen display.

2.Press the “ON/STAND-BY” again to confirm.

3.The cooling fan continues to operate for about 120 seconds for cooling cycle and the POWER LED will flash blue. When the light stop flashing and turn red, the projector has entered standby mode.

If you wish to turn the projector back on, you must wait until the projector has completed the cooling cycle and has entered standby mode. Once in standby mode, simply press “ON/STAND-BY” to restart the projector.

4.Disconnect the power cable from the electrical outlet and the projector.

5.Do not turn on the projector immediately following a power off procedure.

15

English

English

Image 16

Contents Model PDG-DSU30 Table of Contents Precautions Usage NoticeRear Do not Product Features IntroductionPackage Overview NotProduct Overview Connection Ports Computer IN/COMRemote Control ImageInput Remote Control Battery Installation Remote Control Operating RangeConnecting the Projector Connect to Computer/NotebookEnt accessories Connect to VideoPowering On/Off the Projector Powering On the ProjectorPowering Off the Projector Installation Adjusting the Projected Image Adjusting the Height of Projector ImageAdjusting the Projector Zoom and Focus Adjusting Projection Image SizeHow to operate On Screen DisplayBrightness Image ModeContrast Saturation SharpnessTint Image Advanced GammaBrilliantColorTM Color TempReset Image Advanced ColorImage Advanced Input ColorAspect Ratio OverscanImage Shift ZoomKeystone Language LanguageMounting Menu Location VolumeMute Signal Fine SyncTotal Dots Position Horizontal PositionAdvanced LogoInput Search High AltitudeInformation Hide Background ColorPower Mode Direct Power OnAuto Power Off min Sleep Timer minLamp Settings Problem No image appears on screen TroubleshootingProblem Partial, scrolling or incorrectly displayed image Problem Image is unstable or flickering IBM=Problem Image is out of focus Problem The image is stretched when displaying 169 DVDProblem Image is too small or too large Problem Image is reversedProblem LED lighting message POWER-LEDProblem Message Reminders Lamp Replacing Procedure Replacing the lampOrder Replacement Lamp Specifications NTSC-M/NTSC-4.43/PAL-B, D, G, H, I/PAL-M/PAL-N/SECAMModes Resolution Frequency KHz Computer CompatibilityTerminal Analog RGB Mini D-sub 15 pin Configurations of TerminalsTerminal Mini DIN 3-pin Regulation & Safety Notices FCC noticeRemarque à l’intention des utilisateurs cana- diens Manufacturer and Address Authorized Representative and AddressSerial Control Interface OperationFunctional Execution Command FormatStatus Read Command Dimensions KW5A