Sanyo PDG-DSU30 owner manual Rear

Page 4

Warning-

1.5' (50 cm)

Usage Notice

Allowing the proper amount of space on the top, sides, and rear of the projector cabinet is critical for proper air circulation and cooling of the unit. The dimensions shown here indicate the minimum space required. If the projector is to be built into a compartment or similarly enclosed, these minimum distances must be maintained.

 

SIDE and TOP

REAR

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

3' (1 m)

1.5' (50 cm)

1.5' (50 cm)

Warning- Avoid positioning the projector as described below when installing.

Do not roll the projector more than 9 degrees from side to side.

Do not pitch the projector more than 15 degrees from above and below.

Do not point the projector up to project an im- age.

Do not point the projector down to project an image.

Do not put the projector on either side to project an image.

3

English

English

Image 4
Contents Model PDG-DSU30 Table of Contents Precautions Usage NoticeRear Do not Product Features IntroductionPackage Overview NotProduct Overview Connection Ports Computer IN/COMRemote Control ImageInput Remote Control Battery Installation Remote Control Operating RangeConnecting the Projector Connect to Computer/NotebookEnt accessories Connect to VideoPowering On/Off the Projector Powering On the ProjectorPowering Off the Projector Installation Adjusting the Projected Image Adjusting the Height of Projector ImageAdjusting the Projector Zoom and Focus Adjusting Projection Image SizeHow to operate On Screen DisplayBrightness Image ModeContrast Saturation SharpnessTint Image Advanced GammaBrilliantColorTM Color TempReset Image Advanced ColorImage Advanced Input ColorAspect Ratio OverscanImage Shift ZoomKeystone Language LanguageMounting Menu Location VolumeMute Signal Fine SyncTotal Dots Position Horizontal PositionAdvanced LogoInput Search High AltitudeInformation Hide Background ColorPower Mode Direct Power OnAuto Power Off min Sleep Timer minLamp Settings Problem No image appears on screen TroubleshootingProblem Partial, scrolling or incorrectly displayed image Problem Image is unstable or flickering IBM=Problem Image is out of focus Problem The image is stretched when displaying 169 DVDProblem Image is too small or too large Problem Image is reversedProblem LED lighting message POWER-LEDProblem Message Reminders Lamp Replacing Procedure Replacing the lampOrder Replacement Lamp Specifications NTSC-M/NTSC-4.43/PAL-B, D, G, H, I/PAL-M/PAL-N/SECAMModes Resolution Frequency KHz Computer CompatibilityTerminal Analog RGB Mini D-sub 15 pin Configurations of TerminalsTerminal Mini DIN 3-pin Regulation & Safety Notices FCC noticeRemarque à l’intention des utilisateurs cana- diens Manufacturer and Address Authorized Representative and AddressSerial Control Interface OperationFunctional Execution Command FormatStatus Read Command Dimensions KW5A