Troubleshooting
Refer to the symptoms and measures listed below before sending the projector forrepairs. If the problem persists, contact your local reseller or service center. Please refer to "LED Indicator Messages" as well.
Start-up problems
If no lights turn on:
Be sure that the power cord is securely connected to the projector and the other end is plugged into an outlet with power.
Press the ON /
Unplug the power cord and wait for a short while, then plug it in and press the power button again.
Image problems
If the searching source is displayed:
Press the INPUT button one or more times to select another active input source.
Be sure the external source is turned on and connected.
For a computer connection, ensure your notebook computer’s external video port is turned
on. Refer to the computer manual. If the image is out of focus:
Be sure the lens cap is open.
While displaying the
Check the projection lens to see if it needs cleaning.
If the image is flickering or unstable for a computer connection:
Press the AUTO PC button.
Press the MENU button, go to Computer Image and adjust Total dots or Fine sync.
If no image appears on screen:
Turn the projector on.
Check that all connections are setup correctly.
Check that all connected devices are functioning properly.
Remove the lens cap and turn the projector on.
Remote control problems
If the remote control does not operate:
Be sure nothing is blocking the remote control receiver on the front or back of the projector. Use the remote control within the effective range.
Aim the remote control at the screen or at the front or back of the projector.
Move the remote control so it is more directly in front of or behind the projector and not as far to the side.
The battery could be weak. Replace with a new battery.