Hitachi HTS541612J9SA00 Electrical interface specifications, Cabling, Interface connector, 39/167

Page 39

Travelstar 5K160 (SATA) Hard Disk Drive Specification

7 Electrical interface specifications

7.1Cabling

The maximum cable length from the host system to the hard disk drive plus circuit pattern length in the host system shall not exceed 1 meter.

7.2Interface connector

The figure below shows the physical pin location.

Figure 3. Interface connector pin assignments

All pins are in a single row, with a 127 mm(.050”) pitch.

The comments on the mating sequence in Table in the section 7.3 apply to the case of back-plane blind-mate connector only. In this case, the mating sequences are:(1)the ground pins P4 and P12;(2) the pre-charge power pins and the other ground pins; and (3) the signal pins and the rest of the power pins.

There are three power pins for each voltage. One pin from each voltage is used for pre-charge in the backplane blind-mate situation.

If a device uses 3.3V, then all V33 pins must be terminated. Otherwise, it is optional to terminate any of the V33 pins

If a device uses 5.0V, then all V5 pins must be terminated. Otherwise, it is optional to terminate any of the V5 pins

If a device uses 12.0V, then all V12 pins must be terminated. Otherwise, it is optional to terminate any of the V12 pins.

39/167

Page 38 Page 40
Image 39
Page 38 Page 40
Contents 167 Hitachi Travelstar 5K160Copyright Hitachi Global Storage Technologies Table of Contents 11.6 14.30 Limits of temperature and humidity Read Verify Sectors Ext Command 42h List of Tables General Introduction AbbreviationsCapacity GB 10/167 ISO11/167 12/167 Drive handling precautionsReferences General caution13/167 Outline of the drive14/167 Part 1 Functional Specification15/167 Head disk assembly dataFixed disk subsystem description Control ElectronicsLogical Layout Fixed disk characteristicsFormatted capacity by model number Description HTS541616J9SA00 HTS541612J9SA00 Physical LayoutData sheet Cylinder allocation80GB/p format Zone 18/167 Performance characteristicsCommand overhead FunctionAverage latency Mechanical positioningAverage seek time including settling Full stroke seek20/167 Drive ready timeCondition Typical sec Max. sec ReadyOperating modes Mode transition timeOperating mode at power on Adaptive power save controlWrite Cache Data loss on power offWrite safety Data integrityError recovery Data buffer testAutomatic reallocation 24/167 ECCCorrosion test SpecificationTemperature and humidity EnvironmentFrequency KHz Limits uT RMS Radiation noiseConductive noise Magnetic fieldsDC power requirements Requirements27/167 Power consumption efficiency Power consumption efficiency 28/167Capacity 160GB 120GB 80GB 40GB Failure prediction S.M.A.R.T Service life and usage conditionReliability Data reliabilityLoad/unload Preventive maintenanceRequired Power-Off Sequence Power switch design considerations31/167 Test considerationsMechanical specifications Physical dimensions and weightMounting hole locations Mounting orientation Load/unload mechanism33/167 Swept sine vibration Vibration and shockOperating vibration Random vibrationNonoperating vibration Operating shockNonoperating shock Acoustics Sound power levelWeighted Sound Power Typical Bels Maximum Bels Mode definitionsElectromagnetic compatibility Identification labelsSafety PackagingSubstance restriction requirements 39/167 Electrical interface specificationsInterface connector Cabling2 RX+ / RX Signal definitionsPlug Connector pin definition Signal 1 TX+ / TXShows the timing of COMRESET, Cominit and Comwake Out of band signaling42/167 Part 2 Interface SpecificationDevice Device indicates HTS5416XXJ9SA00 Host GeneralIntroduction TerminologyRegister naming convention Deviations from StandardPhysical Interface RegistersDevice Register Command registerError Register Device Control RegisterLBA Mid Register Features RegisterLBA High Register LBA Low RegisterStatus Register Sector Count RegisterReset Response General Operation DescriptionsRegister Initialization Diagnostic and Reset considerations Power-off considerationsExecute Device Diagnostic Emergency unload Sector Addressing ModeRequired power-off sequence Logical CHS Addressing ModePower Management Commands Power Management FeatureLBA Addressing Mode Power ModeStatus Standby/Sleep command completion timingInterface Capability for Power Modes Initial Power Mode at Power OnLow Power Idle mode Interface Power Management Mode Slumber and PartialPerformance Idle mode Active Idle mode12.8 S.M.A.R.T. Function Password Security Mode Feature Set12.8.6 S.M.A.R.T operation with power management modes Security modeOperation from POR after User Password is set Master Password Revision CodeMaster Password setting User Password setting57/167 User Password LostAttempt limit for Security Unlock command Command TableCommand table for device lock operation 59/167 Protected Area Function Read Native Max Address ‘F8’h Set Max Address ‘F9’h60/167 Capacity native 536,870,912 Example for operation In LBA modeSet Max security extension commands Word Content17-255 63/167 Seek OverlapWrite Cache Function Reassign FunctionRecovered read errors 12.14 48-bit Address Feature SetNon recovered write errors Non recovered read errorsSetting Contents Software Setting Preservation Feature SetNative Command Queuing Preserved software settingsCommand Protocol Data In Commands66/167 Non-Data Commands Data Out CommandsRead Fpdma Queued Write Fpdma Queued DMA Data Transfer CommandsFirst-parity DMA Commands Read DMA Read DMA Ext Write DMA Write DMA ExtCommand Descriptions Write Sectors Write Sectors Ext Protocol Command Code HexA.R.T. Read Attribute Thresholds A.R.T. Read Log Sector Write Log ExtCommand Subcommand Command code Feature Hex Output RegistersIndicates that the bit must be set to 71/167 72/167 Input RegistersSector Count LBA Low LBA Mid LBA High Check Power Mode E5h/98hRegister Data Feature Error See Below Device Command Status See Below Error RegisterDevice Configuration Overlay B1h Device Configuration Restore subcommand C0hDevice Configuration Freeze Lock subcommand C1h Sector count 06h = Protected area is now established Device Configuration Identify subcommand C2hDevice Configuration SET subcommand C3h LBA High 03h = word 3 is invalid LBA Mid 00h= Ultra DMA mode 0 is supported = Ultra DMA mode 3 and below are supported= Ultra DMA mode 2 and below are supported = Ultra DMA mode 1 and below are supported77/167 Execute Device Diagnostic 90hFlush Cache E7h Command Block Output RegistersLBA High Current Flush Cache Ext EAhLBA Low Current LBA Mid CurrentFormat Track 50h Vendor Specific Output Parameters To The Device LBA LowLBA High/Mid 81/167 Format Unit F7h Vendor Specific37C8h Number of heads in default translate modeIdentify Device ECh Identify Device response is complete0003H 00xxH 10-19 23-26 27-46Travelstar 5K160 Sata Hard Disk Drive Specification Sata Gen-1 speed 1.5Gbps supported Native Command Queuing supportedRequests Sata Gen-2 speed 3.0Gbps supported00FCH =General Purpose Logging feature set supported =IDLE Immediate with Unload Feature=WRITE DMA Queued FUA EXT command FUA EXT commands supported=READ/WRITE DMA Queued command Enabled112-118 0000H Reserved 119 4000H Maximum user LBA address for 48-bit Address feature set word Output Parameters To The Device Idle E3h/97h92/167 Idle Immediate E1h/95hInitialize Device Parameters 91h 94/167 Read Buffer E4hOutput Parameters To The Device Sector Count Read DMAC8h/C9h96/167 Read DMA Ext 25hData left by previously processed Read or Write commands Read Fpdma Queued 60h97/167 Log Address definition 98/167 Read Log Ext2FhGeneral purpose Log Directory Extended comprehensive Smart error log100/167 Error Log versionError log index Extended Error log data structureDevice error count Extended Self-test log sector101/167 Extended Self-test log descriptor entry Command ErrorSelf-test log data structure revision number Self-test descriptor index103/167 Counter Reset MechanismsPhy Event Counter Counter Identifiers104/167 Read Log Ext Log Page 11hPhy Event Counter Identifier Phy Event Counter informationRead Long 22h/23h Read Multiple C4h Read Multiple Command C4hInput Parameters From The Device LBA Low HOB=0 Read Multiple Ext 29hOutput Parameters To The Device Sector Count Current LBA Low CurrentRead Native Max Address F8h 109/167 Read Native Max Address Ext 27hRead Sectors 20h/21h Head number of the last transferred sector. L=0110/167 111/167 Read Sectors Ext 24h112/167 Error occursRead Verify Sectors 40h/41h Will be verified113/167 Read Verify Sectors Ext 42h114/167 Recalibrate 1xhSecurity Disable Password F6h 116/167 Security Erase Prepare F3hIdentifier Security Erase Unit F4hHTS541660J9SA00 HTS541616J9SA00HTS541612J9SA00 HTS541680J9SA00Security Freeze Lock F5h 19-255 Reserved Security Set Password F1h01-16 Password 32 bytes 17-18 Security level 1-Maximum, 0-HighIdentifier=User / Security level = High PasswordSecurity Level Revision CodeRegards Password as Master Password Security Unlock F2hIdentifier 1-Master, 0-User Head number of the seek Seek 7xhCylinder number of the seek Seek. L=1Sense Condition F0h vendor specific Output Parameters To The Device FeatureSet Features EFh Deepest Power Saving mode is Low power Idle Set Max Address F9h Input Parameters From The Device LBA Low 04hSet Max Address Ext 37h 130/167 Set Multiple C6h 132/167 Sleep E6h/99h133/167 14.40.1 S.M.A.R.T. Sub commands14.40.1.1S.M.A.R.T. Read Attribute Values Subcommand D0h 14.40 S.M.A.R.T Function Set B0h14.40.1.4S.M.A.R.T. Save Attribute Values Subcommand D3h LBA High ErrorStatus LBA Mid136/167 14.40.1.6S.M.A.R.T. Read Log Sector Subcommand D5h14.40.1.7S.M.A.R.T. Write Log Sector Subcommand D6h 14.40.1.8S.M.A.R.T. Enable Operations Subcommand D8h137/167 14.40.1.9S.M.A.R.T. Disable Operations Subcommand D9h14.40.1.10 S.M.A.R.T. Return Status Subcommand DAh F8h Enable Automatic Off-line F9hDevice Attributes Data Structure Data Structure Revision Number138/167 Attribute Name Individual Attribute Data StructureValue Definition Off-Line Data Collection StatusSelf-test execution status Bit Automatic Off-Line Data Collection Status14.40.2.8 S.M.A.R.T. Capability Error Logging CapabilityCurrent Segment Pointer Off-Line Data Collection CapabilityIndividual Thresholds Data Structure Device Attribute Thresholds Data StructureSelf-test completion time Data Structure ChecksumAttribute Threshold 14.40.5 S.M.A.R.T. error log sector14.40.4 S.M.A.R.T. Log Directory Attribute ID Numbers14.40.5.1 S.M.A.R.T. error log version Error log pointerError log data structure Selective self-test log data structure Self-test log data structureError Reporting Error Condition1FCh Reserved 1FEh Data structure checksum 1FFh 512 Standby E2h/96h 148/167 Standby Immediate E0h/94h149/167 Write Buffer E8hWrite DMA CAh/CBh Contains current LBA bits 24 27. L=1150/167 151/167 Write DMA Ext 35h152/167 Write DMA FUA Ext 3DhWrite Fpdma Queued 61h Output Parameters To The Device Feature Current154/167 Write Log Ext 3FhWrite Long 32h/33h Write Multiple C5h 157/167 Write Multiple Ext 39h158/167 Write Multiple FUA Ext CEh159/167 Write Sectors 30h/31h160/167 Write Sectors Ext 34hTimings Erase Unit F4h on Specific on162/167 Index Environment Mounting orientation Non-data commandsShock Signal definitions Sleep Physical dimensions PIO Data In commandsPower management features Service life Set Features166/167 149Copyright Hitachi Global Storage Technologies
Related manuals
Manual 2 pages 51 Kb

HTS541640J9SA00, HTS541616J9SA00, HTS541680J9SA00, HTS541612J9SA00, HTS541660J9SA00 specifications

The Hitachi HTS541660J9SA00, HTS541640J9SA00, HTS541616J9SA00, HTS541680J9SA00, and HTS541612J9SA00 are a series of hard disk drives that showcase Hitachi's commitment to high-performance storage solutions. These drives belong to the Travelstar series, which is designed primarily for mobile computing applications, such as laptops and external storage devices. Their compact design and reliable performance make them suitable for users seeking efficient storage in portable settings.

One of the primary features of these drives is their SATA interface, which allows for fast data transfer rates, thereby enhancing overall system performance. The SATA II interface provides a maximum transfer rate of up to 3.0 Gbps, ensuring that these drives can keep up with the demands of modern computing.

The storage capacity of these models varies, with options such as 160GB, 250GB, and 320GB, catering to diverse user needs for both personal and professional use. The HTS541660J9SA00 provides a generous 160GB capacity, while the HTS541680J9SA00 offers up to 320GB, making them suitable for users who require significant storage space for media files, applications, and documents.

In terms of performance, these hard drives boast a rotational speed of 5400 RPM, striking an optimal balance between speed and energy efficiency. This speed ensures relatively quick access times while consuming less power compared to faster 7200 RPM drives, making them ideal for battery-powered devices.

Another significant characteristic of these drives is the use of Hitachi’s Advanced Format technology. This technology increases the physical sector size of the drives to 4KB, enhancing error correction and overall data integrity. This larger sector size allows for greater data efficiency, significantly reducing the overhead associated with data storage.

Furthermore, these drives are designed with Shock Protection technology, which helps to safeguard the drive's internal components from physical shocks caused by accidental drops or bumps. This feature is especially important for mobile storage solutions, where portability can lead to unintentional impacts.

In conclusion, the Hitachi HTS541660J9SA00, HTS541640J9SA00, HTS541616J9SA00, HTS541680J9SA00, and HTS541612J9SA00 hard disk drives are exemplary choices for anyone seeking reliable, efficient, and portable storage solutions. With their combination of adequate capacity, enhanced data management technologies, and robust design, these drives effectively meet the demands of today’s mobile computing needs.
Top Page Image Contents