Hitachi CP-S860E user manual Turning off the power, Plug & Play, Attach the lens cap

Page 14

Basic operations (continued)

Turning off the power

1

1

VIDEO RGB

LASER

STANDBY/ON POSITION

			RESET
		MENU
	2		FREEZE
	2	MAGNIFY	VOLUME
		MAGNIFY	VOLUME
	3		OFF
	3	P in P	MUTE
		P in P	MUTE
		BLANK	AUTO TIMER

1	Press the STANDBY/ON button for approximately 1 sec.
1	• The ON indicator will blink orange, then the lamp will turn off. Approximately 1 sec. after that, the
	lamp will light orange.
	• After the power is turned off, the lamp will be cooled for approximately 1 min. and the power cannot
	be turned off even by pressing the STANDBY/ON button.
	• The standby status will not be entered if the time which the STANDBY/ON button is pressed is too
	short.

2	Turn off the main power switch of the projector [ : OFF].
3	Attach the lens cap.

Caution The fan will continue running for approximately 1 min. after the STANDBY/ON button is pressed. Do not turn off the main power switch while the lamp is on because this will shorten the service life of the lamp.

Plug & Play

This projector is VESA DDC 1/2B compatible. Plug & play is possible by connecting to a computer that is VESA DDC (Display Data Channel) compatible.

(Plug & play is a system configured with peripheral equipment including a computer and display, and an operating system.

Caution Use the RGB cable included with this projector when using plug & play. With other cables, pins (12) - (15) are sometimes not connected (effective only for RGB).

14

Image 14

Contents Outline FeaturesContentsPage Page Before Use Do not look through the lens when the lamp is on If a problem should occurDo not install on an unstable surface Use only the indicated power supplyDo not allow the laser beam to enter the eyes Handle the power cord with careDo not position the power Clean the projector interior once every two years Care and maintenanceBattery usage Avoid installation in humid or dusty locationsLens care Sound volumeAvoid excessively hot locations Cabinet careChecking the package Contents Names and functions of each partNames and functions of each part Remote control transmitter Disk PAD2Loading the batteries 1Remove the battery cover3Close the battery cover Using the adjusters InstallationTypical LCD Projector and Screen Installation Top view Side viewBasic operations To projectPlug & Play Turning off the powerTurn off the main power switch of the projector OFF Press the STANDBY/ON button for approximately 1 secPress the Freeze button Cancelling the Freeze functionFreeze function Moving the display area Magnify functionChanging the magnification ratio Returning to normal displayPress the Menu Adjustments and functionsReturning to the initial settings Using the Setup Menu Input RGBKeystone BlankTimer LanguageInput signals Connection to the video signal terminalsConnection to the RGB signal terminal Signal input jacksConnection to the RGB signal terminal Example of computer signalConnection to the RGB signal terminal Initial set signalsConnecting the USB Connection to the control signal terminal Mouse functionsConnection to the control signal terminal Control signal jackRS232C communication Command data chart System VideoRequesting projector status Pull out the power cord Remove the front air filter Example of system setupCleaning the Air filter Lamp Cleaning the air filter with a vacuum cleanerInstalling the air filter Message tableWhen you think something wrong IndicatorsSpecifications Dimensional DiagramRepairs after the warranty period has elapsed About the warranty and after-serviceAbout the warranty