Hitachi CP-S860E user manual Before Use

Page 3

Before Use

<Before Using>

About the Symbols Various symbols are used in this instruction manual and on the product itself to ensure correct usage, to prevent danger to the user and others, and to prevent property damage. The meanings of these symbols are described below. It is important that you read these descriptions thoroughly and fully understand the contents.

Warning Caution

This symbol indicates information that, if ignored, could possibly result in personal injury or even death due to incorrect handling.

This symbol indicates information that, if ignored, could result possibly in personal injury or physical damage due to incorrect handling.

Typical Symbols

This symbol indicates an additional warning (including cautions). An illustration is provided to clarify the contents (the illustration to the left indicates danger of electrical shock).

This symbol indicates a prohibited action. The contents will be clearly indicated in an illustration or nearby (the symbol to the left indicates that disassembly is prohibited).

This symbol indicates a compulsory action. The contents will be clearly indicated in an illustration or nearby (the symbol to the left indicates that the power plug should be disconnected from the power outlet).

3

Image 3
Contents Features ContentsPageOutline Page Before Use Use only the indicated power supply If a problem should occurDo not install on an unstable surface Do not look through the lens when the lamp is onHandle the power cord with care Do not position the powerDo not allow the laser beam to enter the eyes Avoid installation in humid or dusty locations Care and maintenanceBattery usage Clean the projector interior once every two yearsCabinet care Sound volumeAvoid excessively hot locations Lens careNames and functions of each part Checking the package ContentsNames and functions of each part Disk PAD Remote control transmitter1Remove the battery cover 3Close the battery cover2Loading the batteries Top view Side view InstallationTypical LCD Projector and Screen Installation Using the adjustersTo project Basic operationsPress the STANDBY/ON button for approximately 1 sec Turning off the powerTurn off the main power switch of the projector OFF Plug & PlayCancelling the Freeze function Freeze functionPress the Freeze button Returning to normal display Magnify functionChanging the magnification ratio Moving the display areaAdjustments and functions Returning to the initial settingsPress the Menu Using the Setup Menu RGB InputBlank KeystoneLanguage TimerSignal input jacks Connection to the video signal terminalsConnection to the RGB signal terminal Input signalsExample of computer signal Connection to the RGB signal terminalInitial set signals Connection to the RGB signal terminalConnecting the USB Mouse functions Connection to the control signal terminalControl signal jack Connection to the control signal terminalRS232C communication System Video Command data chartRequesting projector status Example of system setup Cleaning the Air filterPull out the power cord Remove the front air filter Message table Cleaning the air filter with a vacuum cleanerInstalling the air filter LampIndicators When you think something wrongDimensional Diagram SpecificationsAbout the warranty and after-service About the warrantyRepairs after the warranty period has elapsed