Hitachi CP-S860E user manual Cancelling the Freeze function, Press the Freeze button

Page 15

Basic operations (continued)

Freeze function

This function is used to freeze the image being displayed.

This function can be used together with the MAGNIFY function (refer to page 10).

VIDEO RGB

LASER

STANDBY/ON POSITION

RESET

MENU

	FREEZE
MAGNIFY	VOLUME
1	OFF
	OFF
P in P	MUTE
BLANK	AUTO TIMER

1	Press the FREEZE button.
	• The image being displayed will freeze.

• The [ ] mark will be displayed for approximately 3 sec. when the FREEZE function is on.

Cancelling the FREEZE function

1	Press the FREEZE button.
	• The FREEZE function will be cancelled.

• The [ ] mark will be displayed for approximately 3 sec. when the FREEZE function is cancelled.

Caution • Pressing the FREEZE button alternately turns the freeze function on and off.

•The FREEZE function will be cancelled when the input select button is pressed or the display mode of the PC being used for display is changed.

•The POSITION icon is not displayed while the FREEZE function is being used. The screen cannot be moved with DISK PAD.

•When a still image signal is input when the FREEZE function is on, make sure not to forget to cancel the FREEZE function.

•Cancelled when the menu display is turned on during freeze operation.

15

Image 15

Contents Features ContentsPageOutline Page Before Use Use only the indicated power supply If a problem should occurDo not install on an unstable surface Do not look through the lens when the lamp is onHandle the power cord with care Do not position the powerDo not allow the laser beam to enter the eyes Avoid installation in humid or dusty locations Care and maintenanceBattery usage Clean the projector interior once every two yearsCabinet care Sound volumeAvoid excessively hot locations Lens careNames and functions of each part Checking the package ContentsNames and functions of each part Disk PAD Remote control transmitter1Remove the battery cover 3Close the battery cover2Loading the batteries Top view Side view InstallationTypical LCD Projector and Screen Installation Using the adjustersTo project Basic operationsPress the STANDBY/ON button for approximately 1 sec Turning off the powerTurn off the main power switch of the projector OFF Plug & PlayCancelling the Freeze function Freeze functionPress the Freeze button Returning to normal display Magnify functionChanging the magnification ratio Moving the display areaAdjustments and functions Returning to the initial settingsPress the Menu Using the Setup Menu RGB InputBlank KeystoneLanguage TimerSignal input jacks Connection to the video signal terminalsConnection to the RGB signal terminal Input signalsExample of computer signal Connection to the RGB signal terminalInitial set signals Connection to the RGB signal terminalConnecting the USB Mouse functions Connection to the control signal terminalControl signal jack Connection to the control signal terminalRS232C communication System Video Command data chartRequesting projector status Example of system setup Cleaning the Air filterPull out the power cord Remove the front air filter Message table Cleaning the air filter with a vacuum cleanerInstalling the air filter LampIndicators When you think something wrongDimensional Diagram SpecificationsAbout the warranty and after-service About the warrantyRepairs after the warranty period has elapsed