Conference Room Scheduler Installation Guide | Application Configuration |
Step 3 – Facilities (Conf_Room_Sch only)
According to instructions in the APM Operations Manual, designate the following NEAX2400 facilities for the Conf_Room_Sch component using the Facilities command on the APM Configuration Entry screen:
MRFI | Mode Release Facility (I) |
MRFR | Mode Release Facility (R) |
MSF | OAI Mode Set Facility |
NTF | Number Transfer Facility |
TCFD | Terminal Control Facility (D) |
Note: The same MSF identification number (i.e., from 128 to 192) that is selected in the
APM during Step 3 must be assigned to Conference Room Scheduler at the NEAX
MAT. For more information, see Chapter 4 .
Step 4 – Secondary OAI Configuration Parameters (Conf_Room_Sch only)
Using the
Parameter | Entry | Definition |
|
|
|
Database Name #1 | /oai/db/cur/crminfofil | Indicates the path name of the database |
|
| containing the conference room |
|
| information. This name must be the |
|
| first listed database. The database |
|
| filename (i.e., crminfofil), listed here |
|
| with its path, should be used as the |
|
| name of the corresponding Application |
|
| Definition File (Refer to Chapter 3.) |
|
|
|
Database Name #2 | /oai/db/cur/crmidfile | Indicates the path name of the database |
|
| containing the employee identification |
|
| data. This name must be the second |
|
| listed database. The database filename |
|
| (i.e., crmidfile), listed here with its |
|
| path, should be used as the name of the |
|
| corresponding Application Definition |
|
| File (Refer to Chapter 3.) |
|
|
|
Timeout Value #1 | 90 | Designates the number of seconds |
|
| Conf_Room_Sch will wait for user |
|
| input before it will release the Dterm. |
Tenant Number | 0 | Specifies the number of the tenant that |
|
| Conf_Room_Sch serves. |
|
|
|
Page 5 |