Top Features
1Power Button
Use this button to turn the power on and off when Main Power Switch is on and the LCD projector is on standby. (When this button is pressed and held for at least two seconds, the “Display Mute” mode will be canceled.)
2Menu Button
Displays the on- screen menu.
3Select Button
After you press the “Menu” button, use this button to select the menu icon of the item you wish to adjust.
4Enter Button
Executes your menu selection.
5(+) (–) Adjust Button
Use these buttons while you' re in the Image Adjust mode to change the level of a selected menu item. These but- tons are also used to set an item in the Power or Settings menus.
6(+)
Press the (+) button to make the image larger; press
7(+)
Press the (+) or
8Power Indicator
When this indicator is green, the LCD projector is on; when the indicator is amber, it is standing by.
9Status Indicator
When this is lit red continually, it's warning you that the projection lamp has exceed 2000 hours of service. After this light appears, it is advisable to replace the projection lamp as soon as possible.(See page
When the operating time of the lamp exceeds 2000 hours, the STATUS indicator is lit red continually. In addition the message "LAMP USAGE XX HOURS" appears con- tinually when the
If this light blinks red rapidly, it indicates that either the lamp cover or filter cover is not attached properly; if the light blinks slowly it means the projector's internal tem- perature is too hot to operate safely. See the Status Light Messages on page
FOCUS
ZOOM
ADJUST
ENTER
SELECT
MENU
PUSH POWER |
| STATUS |
| ||
ON/OFF |
|
|
|
| |
|
|
|
7
6
5
4
3
2
1
9
8
E – 8