Terminal Panel Features

This panel is located in the rear and is where you connect your cables.

1Remote Control Jacks

a. Remote Control Input Jack

Connect your remote control cable here for wired opera- tion.

b. Remote Control Output Jack

This terminal enables you to operate up to five LCD projectors with the same remote control.

When your remote mouse receiver is connected here, the remote sensors on the LCD projector cabinet will receive your mouse commands.

2PC Control Port

Use this port to connect your PC to control the MultiSync MT1020G/820G Projector. This enables you to use your PC and serial communication protocol to control the projector. If you are writing your own program, com- mand references are on pages E-36.

312V DC/400 mA Output Terminal

Use this terminal to plug in a document camera or any other 12V accessory.

4Video Input

Connect a VCR, laser disk player, or document camera here to project video.

Left Channel/Mono Audio Input Jack

This is your left channel audio input for stereo sound coming from video equipment or audio system. This also serves as your monaural audio input.

Right Channel Audio Input Jack

This is your right channel audio input for stereo sound.

5S-Video Input

Here is where you connect S-Video input from an exter- nal source like a VCR.

Left Channel/Mono Audio Input Jack

This is your left channel audio input for stereo sound coming from S-Video equipment or audio system. This also serves as your monaural audio input.

Right Channel Audio Input Jack

This is your right channel audio input for stereo sound.

NOTE: S-Video provides more vivid color and higher resolution than the traditional composite video format.

1 a	1 b	2	3
		PC	DC12V/400mA
REMOTE CONTROL		CONTROL		OUTPUT
INPUT	OUTPUT
INPUT	OUTPUT

VIDEO INPUT	AUDIO INPUT
L / MONO		R
4
S-VIDEO INPUT		AUDIO OUTPUT
5
L / MONO		R
RGB INPUT 1		AUDIO
		RGB MONITOR OUTPUT
RGB INPUT 2		AUDIO

E – 9