7. Appendix
Troubleshooting Check List
Before contacting your dealer or service personnel, check the following list to be sure repairs are needed also by referring to the “Troubleshooting” section in your user’s manual. This checklist below will help us solve your problem more efficiently.
* Print the following pages.
Frequency of occurrence ☐ always ☐ sometimes (How often?_____________________) ☐ other (__________________)
Power
No power (POWER indicator does not light green) See also “Sta- tus Indicator (STATUS)”.
Power cable's plug is fully inserted into the wall outlet.
Main power switch is pressed to the ON position.
Lamp cover is installed correctly .
Lamp Hours Used (lamp operation hours) was cleared after lamp replacement.
No power even though you press and hold the POWER button for 1 second.
Video and Audio
Shut down during operation.
Power cable's plug is fully inserted into the wall outlet.
Lamp cover is installed correctly .
Power Management is turned off (only models with the Power Management function).
Off Timer is turned off (only models with the Off Timer function ).
No image is displayed from your PC or video equipment to the projector.
Still no image even though you connect the projector to the PC first, then start the PC.
Enabling your notebook PC’s signal output to the projector.
•A combination of function keys will enable/disable the ex- ternal display. Usually, the combination of the “Fn” key along with one of the 12 function keys turns the external display on or off.
No image (blue or black background, no display).
Still no image even though you press the AUTO ADJUST but- ton.
Still no image even though you carry out [Reset] in the projector’s menu.
Signal cable's plug is fully inserted into the input connector
A message appears on the screen.
( _____________________________________________ )
The source connected to the projector is active and available.
Still no image even though you adjust the brightness and/or the contrast.
Input source's resolution and frequency are supported by the projector.
Image is too dark.
Remains unchanged even though you adjust the brightness and/or the contrast.
Image is distorted.
Image appears to be trapezoidal (unchanged even though you carry out the [Keystone] adjustment).
Parts of the image are lost.
Still unchanged even though you press the AUTO ADJUST but- ton.
Still unchanged even though you carry out [Reset] in the projector’s menu.
Image is shifted in the vertical or horizontal direction.
Horizontal and vertical positions are correctly adjusted on a computer signal.
Input source's resolution and frequency are supported by the projector.
Some pixels are lost.
Image is flickering.
Still unchanged even though you press the AUTO ADJUST but- ton.
Still unchanged even though you carry out [Reset] in the projector’s menu.
Image shows flickering or color drift on a computer signal.
Image appears blurry or out of focus.
Still unchanged even though you checked the signal’s resolu- tion on PC and changed it to projector’s native resolution.
Still unchanged even though you adjusted the focus.
No sound.
Audio cable is correctly connected to the audio input of the projector.
Still unchanged even though you adjusted the volume level.
AUDIO OUT is connected to your audio equipment (only mod- els with the AUDIO OUT connector).
Other
Remote control does not work.
No obstacles between the sensor of the projector and the re- mote control.
Projector is placed near a fluorescent light that can disturb the infrared remote controls.
Batteries are new and are not reversed in installation.
Buttons on the projector cabinet do not work ( only models with the Key Lock function).
Control Panel Lock is not turned on or is disabled in the menu.
Still unchanged even though you press and hold the EXIT but- ton for a minimum of 10 seconds.
64