7 Troubleshooting
Warning
••Risk of electric shock. Never remove the casing of the product.
To keep the warranty valid, never try to repair the product yourself.
If you have problems using this product, check the following points before you request service. If you still have a problem, get support at www. philips.com/support.
Main unit
The buttons on the SoundBar do not work.
•Disconnect the SoundBar from the power supply for a few minutes, then reconnect.
Sound
No sound from SoundBar speakers.
•Connect the audio cable from your SoundBar to your TV or other devices.
•Reset your SoundBar to its factory settings.
•On the remote control, select the correct audio input.
•Make sure that the SoundBar is not muted.
Distorted sound or echo.
•If you play audio from the TV through the SoundBar, make sure that the TV is muted.
8 Notice
This section contains the legal and trademark | E n g l i s h |
| |
notices. |
|
Notice of compliance
This set complies with the FCC rules, Part
15.Operation is subject to the following two conditions:
AThis device may not cause harmful interference, and
BThis device must accept any interference received, including interference that may cause undesired operation.
FCC rules
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Relocate the receiving antenna.
•Increase the separation between equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
EN 11