Kodak KY0730485 quick start Product Safety and Compliance

Page 4

Matchprint Professional Server for DocuColor 12 Printer/Copier – Quick Start

Product Safety and Compliance

Warning!

Do not modify or use any AC power cord other than the one included with shipping.

In some cases, the supplied power cord may not be compatible with the AC wall outlet in your region. If this is true, you must obtain a suitable power cord that meets the following criteria:

The cord must be rated for use at the AC voltage available, with a current rating that is at least 125% of the current rating of the product.

The AC plug end must be terminated in a grounding-type male plug designed for use in your region. The plug ends must be labeled or marked to indicate they have been certified by an agency acceptable in your region.

The connector at the product end must be an IEC 320, sheet C13, female connector (or the equivalent EN 60 320 connector.)

The cord must be less than 14.8 feet (4.5 meters) long and, for use in Europe, be created with <HAR> (harmonized) or VDE certified cordage.

Warning!

1.The user must never remove chassis covers. Some system circuitry retains voltage even when the system is turned off. Only qualified service technicians should remove chassis covers.

2.There are no user-serviceable components in the KPG server. Refer all system repair to a qualified service technician.

Warning!

The power supply voltage standby circuit is active when the computer is turned off. Ensure that the computer is disconnected from its power source and from all telecommunication links, networks, or modem lines whenever the chassis cover is removed. Do not operate the computer with the cover removed. Only qualified service technicians should remove chassis covers if repair or component replacement is required.

Warning!

Danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the equipment manufacturer. Discard used batteries according to manufacturer's instructions.

2002 Kodak Polychrome Graphics. All Rights Reserved.

4

 

Image 4
Contents Professional Server Trademarks Table of Contents Product Safety and Compliance Avertissement Service Information Quick Start Steps Printer SetupStarting the Software MPS RIP Printer Calibration Spectrocam Setup 2002 Kodak Polychrome Graphics. All Rights Reserved 2002 Kodak Polychrome Graphics. All Rights Reserved Scanner Left corner of the test form Click on OK to return to the calibration window Spectrocam TIPs Adding a Spooler 2002 Kodak Polychrome Graphics. All Rights Reserved Adding a Hot Folder 2002 Kodak Polychrome Graphics. All Rights Reserved General Tab Setting PreferencesJob Parameters Metric Media Size US Media Size Cache TabPaths Tab Roles Tab Installing PPDs Job PrintingTo print to a Hot Folder or Spooler To print a job from the Matchprint Professional Server2002 Kodak Polychrome Graphics. All Rights Reserved