Kodak 3020 instruction manual Lamp setting, 9020

III.With the Autotimer function via IR remotecontrol(EKTAPRO7020and9020) Automatic slide shows can be programmed directly via remote control with the Auto- timer function. You can input times be- tween 1 and 60 seconds! Use the number combinations 601 - 660.

Then use the <*> key to confirm. The first slide is then transported immediately, the next one in the preprogrammed time. By inputting <600> and <*> you switch the autotimer off again (see also separate man- ual).

Note

The Autotimer function takes prece- dence over times which are set on the built-in timer (model 9020)!

Automatic zero positioning (EKTAPRO 9020)

TheKODAKEKTAPRO9020SlideProjec- tor has an automatic zero positioning selec- tor switch (8). When switched on, it auto- matically returns the tray to the zero position, via the quickest route, as soon as the slide gate is empty.

The automatic zero-positioning is particu- larly useful for presentations with few slides and in continuous operation (see p. 32).

Standby Function	Lamp setting
1./ 2.	You can run the lamp of your projector in
	standard mode,economy modeandalsoin
	high light mode on the models 7020 and
	9020.

			1.
1.Projector in Standby:		2.
			1.Economy Setting:
Press the standby button	(3) on the
projector or remote control.
The projection lamp and the fan will be				Move switch (4) .
switched off. The tray remains in its posi-			2.Standard Setting:
tion!
In addition on models 4020, 5020, 7020 and			Return the switch (4) to original position.
9020 the standby status is indicated by the			The economy setting offers you approxi-
red LED (18) flashing!			mately three times longer life-span by re-
2.Projector in operation:			ducing the projection brightness.
			The setting can be changed by the lamp
			economy switch.
Press again the standby button on the			.High light mode (models 7020 and
projector or remote control. The presenta-
tion can now be continued.		9020)
			Push the switch (4) backwards and for-
Standby			wards once within 1 second. This takes the
The standby function enables you to inter-			projector into high light mode. The lamp
rupt and restart at any time during your			display of the lamp currently on (L1 or L2,
presentations.			(26)) begins to flash. Lamp output is in-
Standby places the projector in readiness			creased by 20%, although this reduces the
for operation.			lamp life by around 30%! As soon as you
			move the switch (4) once again you cancel
Note (EKTAPRO 4020, 5020, 7020 and			the high light mode!
9020):
In any case the projector goes definitely			N.B. Projection time must not exceed 1
on standby (independent of which mode			minute per slide. See special instructions
it was in) if the standby key has been			on page 25.
pressed for longer than 2 seconds! If the
projector was on standby it will be			Note
switched on again and will then go			You can find information on the output
again on standby.			of the projection lamps on page 36.
Standby is not possible if the slot for		.
modules (35) is engaged with the
KODAK EKTAPRO 12/7-Pol Module.

28