Kodak 3020 instruction manual Service, Continuous projection, Replacement of a defective lamp

Page 15

Service

Continuous projection

You can either run automatic slide shows using the built-in timer (EKTAPRO 5020 and 9020) or via the IR remote control using the Autotimer function (EKTAPRO 7020 and 9020 -in single or in the MASTER/ SLAVE combination). This makes slide change times between 1 and 60 seconds possible. For further information please see under “Timer”, page 27 or in the separate manual under "Autotimer".

Note (EKTAPRO 4020/5020/7020 Projector)

In order to avoid "dark pause" it is recommended that the slide tray is filled as completely as possible.

KODAKEKTAPRO9020Projector You can immediately bring the tray back to the zero position after the last slide with the help of the automatic zero positioning fea- ture. This is useful when continuous pro- jection is required using only a few slides. By pressing the switch (8), you can activate the automatic zero positioning.

Replacement of a defective lamp

WARNING:

Before pulling out the lamp module, switch off the projector and unplug the mains lead first!

For lamp replacement let the module cool down before touching the lamp and the surrounding area. Do not place the hot lampmodule on heat sensitive surfaces. Glass may shatter. Wear gloves. Keep glass covered.

Do not touch the small bulb or the mirror surface! If you accidentally get finger prints on them, remove marks with a soft cloth moistened with rubbing alcohol.

Replacement of a defective lamp is very easy with your EKTAPRO Slide Projector:

1.	4.

3.

2.

1.Press down and hold down the lamp module release (28) and...

2.... pull out the lamp module (20).

.Push the lamp ejector lever down so that it clears the retaining clip.

Note:

For your projection requirements you have a choice of 3 lamps with different brightness and lamp life (see Accesso- ries page 35).

3.Push the ejector lever completely to the side.

The defective lamp will come free of it’s holder.

4.Remove the defective lamp and in- sert the new lamp.

.Push the ejector lever back to the right and press down until it locks into its hold- ing.

.Push the lamp module back into the projector until it locks.

32

Image 15

Contents Kodak Ektapro 3020 4020 5020 7020 Page Content Projector-FeaturesRadiointerference Electrical Approvals and Conformity MarkElectricalApprovals CEConformityMarkImportant Safety Precautions Introduction Switching- on the projector Switching-on the projectorCheck voltage setting Setting of a different operation voltageTray positioning index mark Loading and installing the slide trayTo reduce slide temperature and light output Extra Bright LampLine-up Ektapro 4020, 5020, 7020 Setting up the projectorFitting the lens Leveling the projectorOperation Slide changingPlease note 9020 Lamp settingRemoving the slide tray in any position Fastening or mounting the projectorMove tray to zero position Random access operation RedLEDL1litRedLEDL2lit With the Kodak Ektapro Twin Socket Adapter accessory Using the Kodak Ektapro IR Re- mote SystemsSimultaneous Projection Service Replacement of a defective lampContinuous projection Please note These fuses are different! See technical data, Replacement of fusesMaintenance and guarantee Cleaning the projector3UREOHP 3RVVLEOHUHDVRQV +HOS Possible problems during operationAccessories Mechanical System Illumination Technical DataConnectors Interfaces Electrical SystemControl system Kodak /HQVHV $..7$352Page = 35 mm Page Germany Australia