| Extra Bright Lamp |
Loading and installing the slide tray | Module - Important Hints |
1. Check that the baseplate of the slide tray is locked into
With the higher light ouput of the Extra Bright Lamp Module the temperature in the slide gate rises. To enable a smooth oper- ation following hints should be consid-
2. Load the slides up- side down for normal front projection.
. Replace and lock the 
cover to prevent damage 
and splitting in case the tray 
is dropped or turned over. 
3. Place the loaded tray into its zero position on the projector’s transport ring (15). The cleft in the slide tray (zero posi- tion) fits on to the notch of the transport ring.
Tray positioning index mark
2.
3.
ered:
1.Use only light respectively light gray slide mounts (e.g. Wess slide mounts). Slide mounts with only one dark side or black side have to be sorted in respectively, mounted with the side facing the lamp. Please pay special attention when sorting your slide mounts in rear projections:
2. Do not use a lamp type EXW/15 h for the |
projector (higher temperature - lamp not |
available from Kodak). |
3. Consider the room temperature! It may |
not exceed 35 degrees C! |
4. |
9010, 9020): Slide projection time per slide |
Note:
• To avoid annoying automatic refocus- ing during presentation, damaged, distorted or warped slides should not be used as they may jam the projector`s transport mechanism.
• A slide tray index (80 slides) for copying can be found on page 86. This is ideal for archiving and an index copy can be made for each slide tray.
Projectors are often installed on racks where tray installation may be difficult and only possible from the rear of the projector. In this case the tray positioning index mark
(27)on the back of the projector is very helpful: The tray is properly set when the index mark aligns with the mark placed on the tray (at slide no. 20 of the 80 slide tray and at slide no. 35 on the 140 slide tray).
may not exceed 1 minute! |
If these hints are not considered,
mountsmaydeform!
5. Glass mounted slides can produce sweat spots due to the high temperature in long term projections. As soon as the slide has warmed up these sweat spots disappear.
To reduce slide temperature (and light output):
a)Install a
b)Use the lamp economy switch, or
c)install a 200 h lamp (see Accessories p. 35)
25