Kyocera 3035 manual Loading paper into the multi-bypass tray

Section 3 PREPARATIONS

5Set the supplied paper size sheet so that the size of the paper loaded can be checked by looking at the front of the

drawer[cassette].

6Gently push the drawer[cassette] back in.

NOTE

Before leaving the copier in disuse for a prolonged period of time, remove the paper from the drawer(s)[cassette(s)] and seal it in its original packaging to protect from moisture. Also, when storing paper in a high temperature and high humidity environment, seal it in a moisture-proof bag.

(3) Loading paper into the multi-bypass tray

Up to 200 sheets of standard copy paper (75 g/m2 – 80 g/m2), of a size between 11" x 17" [A3] and 5 1/2" x 8 1/2" [A6R] can be set on the multi-bypass tray at one time. When copying onto special paper, be sure to use the multi-bypass tray.

NOTE

The types of special paper and the number of sheets that can be loaded in the multi-bypass tray are:

•Transparencies: 25 sheets

•Standard paper (120 g/m2): 130 sheets

•Standard paper (160 g/m2): 100 sheets

IMPORTANT!

•When copying onto OHP transparencies, be sure to fan through them a few times to separate the sheets before setting them on the multi-bypass tray.

•When copying onto non-standard size paper, perform the procedure in “(1) Paper size and type” on page 7-87 and select the paper size.

•When setting special paper such as OHP transparencies and thick paper on the multi-bypass tray, the type of paper must be specified under “(1) Paper size and type” on page 7-87.

•You can select to have the “Bypass setting” screen (see page 7-86) displayed whenever the “Bypass” key is touched. (See “Multi-bypass tray setting display ON/OFF” on page 7-45.)

1Open the multi-bypass tray.

2Adjust the insert guides to the size of the paper to be loaded.

3	Insert the paper along the guides as far as it will go.
IMPORTANT!

•When you are setting paper onto the multi-bypass tray, make sure that the side facing upward when the package is opened is the side that is facing upward on the multi-bypass tray as well. In addition, if the leading edge of the paper is curled at all, straighten it out before setting it on the multi-bypass tray.

•ALWAYS straighten out curled paper before setting it on the multi- bypass tray.

3-3