Some label paper is manufactured with an extra margin of top sheet around the edge. Do not remove the extra top sheet from the carrier sheet until after printing is finished.
AcceptableUnacceptable
Top sheet 
Carrier sheet 
The table below lists the specifications for adhesive label paper.
Item | Specification |
|
|
Weight of top sheet | 44 to 74g/m² (12 to 20 lb/ream) |
Composite weight | 104 to 151g/m² (28 to 40 lb/ream) |
Thickness of top sheet | 0.086 to 0.107mm (3.9 to 4.2 mils) |
Composite thickness | 0.115 to 0.145mm (4.5 to 5.7 mils) |
Moisture content | 4 to 6% (composite) |
Postcards
Up to 10 postcards can be loaded at a time. Fan the stack of postcards and align the edges before loading them in the MP tray. Make sure the postcards you are going to set are not curled. Feeding curled postcards may cause paper jams.
Some postcards have rough edges on the back (those are created when the paper is cut). In this case, put the postcards on a flat place and rub the edges with, for example, a ruler to smooth them.
Envelopes
Up to 5 envelopes can be loaded at a time. Envelopes should be fed in the
Since the composition of an envelope is more complex than that of ordinary paper, it is not always possible to ensure consistent printing quality over the entire envelope surface.
Normally, envelopes have a diagonal grain direction. Refer to Paper Grain on page
•Do not use envelopes that have an encapsulated liquid adhesive.
•Avoid a long printing session for envelopes only. Extended envelope printing can cause premature printer wear.
•If jams occur, try setting less envelopes on the MP tray.
•To avoid jams caused by curled envelopes, stack no more than 10 printed envelopes on the output tray.
Loading Paper |