NEC LCD194WXM, LCD224WXM Removing the Base, Pull out the unlocked Base, Connecting a Flexible Arm

Quick Start - continued

Removing the Base

Release Tab

Note: Always remove the Base when shipping the LCD.

1. Place monitor face down on a non-abrasive surface.

2. Using your fingers, press the

3 release tabs on left or right side at the same time to unlock the Base.

3. Using your fingers, press the 3 release tabs on the other side at the same time to unlock the Base.

4. Pull out the unlocked Base.

Connecting a Flexible Arm

This LCD monitor is designed for use with a flexible arm. Please use the attached screws (4pcs) as shown in the picture when installing.

To meet the safety requirements, the monitor must be mounted to an arm which guaranties the necessary stability under consideration of the weight of the monitor. The LCD monitor should only be used with an approved arm (e.g. GS mark).

NOTE: The mounting stand must be able to sustain at least 15kg (LCD174WXM), 19kg (LCD194WXM), 21kg (LCD224WXM) and be UL certified.

12mm

M4

4 x 12mm with lock washer

and flat washer

100 mm

100 mm

4 SCREWS (M4) (MAX depth: 10.0 mm)

If using other screws, check depth of holes.

Thickness of Bracket (Arm) 2.0~3.2 mm

Tighten all

screws.

Weight of LCD assembly:

LCD174WXM : 3.4 kg (MAX)

LCD194WXM : 4.3 kg (MAX)

LCD224WXM : 4.8 kg (MAX)

6