NEC LCD73VM user manual Controls

Power Button

Headphone

Figure C.1 Figure TS.1

Non-abrasive surface
Figure R.1	Figure R.2

Figure R.3

4 x 12 mm with lock washer and flat washer

Thickness of Bracket (Arm) 2.0 ~ 3.2 mm

Tighten all screws

100 mm

100 mm

Specifications

4-SCREWS (M4)

(MAX depth: 8.5 mm)

Weight of LCD assembly: 3.9 kg - LCD73VM (MAX) 5.2 kg - LCD93VM (MAX)

NOTE: Adjust position of cable that place under the Cable holder to avoid damage for cable or monitor.

NOTE: Please refer to Caution section of this manual for proper selection of power cord.

5.Turn on the monitor with the front power button and the computer (Figure C.1).

6.No-touch Auto Adjust automatically adjusts the monitor to optimal settings upon initial setup for most timings.

For further adjustments, use the following OSM controls:

•Auto Adjust Contrast

•Auto Adjust

Refer to the Controls section of this User’s Manual for a full description of these OSM controls.

NOTE: If you have any problem, please refer to the Troubleshooting section of this User’s Manual.

Tilt

Grasp both sides of the monitor screen with your hands and adjust the tilt as desired (Figure TS.1).

Remove Monitor Stand for Mounting

To prepare the monitor for alternative mounting purposes:

1.Disconnect all cables.

2.Place monitor face down on a non-abrasive surface (Figure R.1).

3.Remove the 2 screws connecting the monitor to the stand and remove the stand as indicated (Figure R.2).

The monitor is now ready for mounting in an alternative manner.

4.Connect the AC cord to the back of the monitor (Figure R.3).

5.Reverse this process to re-attach stand.

NOTE: Use only VESA-compatible alternative mounting method.

NOTE: Handle with care when removing monitor stand.

Removing the Base

NOTE: Always remove the Base when shipping the LCD.

1.Place monitor face down on a non-abrasive surface (Figure R.1).

2.While using your thumbs,

press the bottom tabs upward to unlock.

3.Press the top tabs down to unlock and pull off the stand.

Connecting a Flexible Arm

This LCD monitor is designed for use with a flexible arm.

Please use the attached screws (4pcs) as shown in the picture when installing. To meet the safety requirements, the monitor must be mounted to an arm which guaranties the necessary stability under consideration of the weight of the monitor.

The LCD monitor shall only be used with an approved arm (e.g. GS mark).

English

Controls

OSM (On-Screen Manager) control buttons on the front of the monitor function as follows:

1. Basic function at pressing each key

Button		SELECT		–		+		AUTO/RESET
At No OSD	Showing OSM.		Shortcut to Bright adjust		Shortcut to Volume adjust		“Auto adjust” operate.
showing			window.		window.
At OSD showing	Go to Adjustment stage.		Cursor goes to left.		Cursor goes to right.
(Icon selection stage)
At OSD showing	Go to Icon selection stage.		Adjust value decrease or		Adjust value increase or		Reset operation.
(Adjustment stage)			Cursor for adjust goes to		Cursor for adjust goes to		Mute off/on switch on
			left.		right.		Volume adjustment window.
				English-2

01_English 2 16/5/06, 9:11