NEC user manual Monitor MultiSync LCD2000 Specifications, Native Resolution Pixel Count 1280 x

Monitor		MultiSync® LCD2000™	Notes
Specifications		Monitor
LCD Module	Diagonal:	20.1 inch	Active matrix; thin film transistor (TFT)
Viewable Image Size:		20.1 inch	liquid crystal display (LCD); 0.31 mm dot
Native Resolution (Pixel Count):		1280 x 1024	pitch, XtraView™ technology; 150cd/m2
			white luminence; 100:1 contrast ratio, typical
Input Signal	Video:	ANALOG 0.7 Vp-p/75 Ohms
	Sync:	Separate sync. TTL Level
		Horizontal sync. Positive/Negative
		Vertical sync. Positive/Negative
		Composite sync. (Positive/Negative) (TTL Level)
		Sync on Green video (Positve) 0.7 Vp-p and sync.
		Negative 0.3 Vp-p
Display Colors	Analog input:	Unlimited number of Colors	Depends on display card used.
Synchronization	Horizontal:	24.0 kHz to 80 kHz	Automatically
Range	Vertical:	56.0 Hz to 76 Hz	Automatically
Resolutions Supported		720 x 400*: VGA text	Some systems may not support
Resolution based on horizontal and		640 x 480 at 60Hz to 76Hz	all modes listed.
vertical frequencies only		800 x 600* at 56Hz to 76Hz
		832 x 624* at 75Hz
		1024 x 768* at 60Hz to 76Hz
		1280 x 960 at 60Hz to 76Hz
		1280 x 1024 at 60Hz to 76Hz .................. NEC cites recommended resolution at
			60 Hz for optimal display performance.
Active Display Area	Horizontal:	399 mm/15.7 inches	Dependent upon signal timing used,
	Vertical:	319 mm/12.6 inches	and does not include border area.
Power Supply		AC 100 – 120 V/ 220 – 240 V @ 50/60 Hz
Current Rating		1.0A @ 100 – 120 V/0.5A @ 220 – 240 V
Dimensions		500 mm (W) x 483 mm (H) x 220 mm (D)
		19.7 inches (W) x 19.0 inches (H) x 8.7 inches (D)
Weight		10.0 kg
		22.0 lbs
Environmental Considerations
Operating Temperature:		5°C to +30°C/41°F to 86°F
	Humidity:	30% to 80%
	Feet:	0 to 10,000 Feet
Storage Temperature:		-10°C to +60°C/14°F to 140°F
	Humidity:	10% to 85%
	Feet:	0 to 45,000 Feet

*Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear choppy or lines may appear to be bold. This is normal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel technologies, each dot on the screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done. When the interpolated resolution is not an exact multiple of the native resolution, the mathematical interpolation necessary may cause some lines to appear thicker than others.

NOTE: Technical specifications are subject to change without notice.

9

78132391 11 5/5/98, 8:34 AM