NEC PA231W, PA301W user manual English-5, USB downstream*2 Highest Stand Position

4.Connect all cables to the appropriate connectors (Figure C.1). When using the USB cable, connect the B type connector to the USB upstream port on the right back side of the monitor and the A type connector to the downstream port on the computer (Figure C.1a). If using the cord from a USB device, plug into one of the downstream ports of the monitor.

NOTE: Incorrect cable connections may result in irregular operation, damage display quality/components of LCD module and/or shorten the module’s life.

English

30° Tilt

USB downstream*2

Highest

Stand

Position

USB downstream
USB upstream1
USB upstream2		DisplayPort-2*4
		DVI-1		D-SUB*1
	DisplayPort*3		DVI-2

A Type

A Type

B Type

B Type

Figure C.1a

DC-OUT*

Power cord

*NEC optional product attachment (except PA301W). Do not use this connector unless specifi ed.

Figure C.1

5.To keep the cables neatly organized, place them into the cable management system that is built into the stand. Place the cables in the hooks fi rmly and evenly (Figure C.2 and Figure C.3).

6.Please check that you can still rotate, raise and lower the monitor screen when you have installed the cables.

D-SUB Cable*1

DVI-1 Cable

Power Cord

USB Cable

DisplayPort

Cable

Power Cord

D-SUB Cable*1

DVI-1/DVI-2 Cables

DisplayPort Cable

USB Cable

	Figure C.2	Figure C.3
*1	Only for PA231W/PA241W.
*2	Connect sensor to this port for self calibration (PA301W). (See page 34)
*3	DisplayPort-1 for PA301W.
*4	Only for PA301W.

English-5