NEC PA271W, PA241W user manual Quick Start, English-4

Quick Start

To connect the LCD monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.For a PC or MAC with DVI digital output: Connect the DVI signal cable to the connector of the display card in your system (Figure A.1). Tighten all screws.

For a PC with Analog output (only for PA241W): Connect a 15-pin mini D-SUB to DVI-A signal cable (not included) to the connector of the display card in your system (Figure A.2).

For a MAC (only for PA241W): Connect a Macintosh cable adapter (not included) to the computer, then attach the 15-pin mini D-SUB signal cable to the Macintosh cable adapter (Figure A.3).

NOTE: Some Macintosh systems do not require a Macintosh cable adapter.

For a PC with DisplayPort output: Connect the DisplayPort cable to the connector of the display card in your system (Figure A.4).

	Macintosh Cable	Figure A.3	DisplayPort cable	Figure A.4
Figure A.1	Figure A.2 Adapter
	(not included)

NOTE: 1. Please use a DisplayPort cable with a DisplayPort logo.

2.When removing the DisplayPort cable, hold down the top button to release the lock.

3.Height adjustment is locked by lock button. Place hand on top of the monitor to push down the screen to the lowest position. Slide the lock button to unlock (Figure B.1).

NOTE: Handle with care when unlocking stand.

Place hands on each side of the monitor to tilt the LCD panel 30-degree angle and lift up to the highest position. Slide the cable cover up (Figure B.2).

NOTE: Cable cover is not removable.

30° Tilt

Cable cover

Figure B.1 Figure B.2

English-4