3Make sure you loaded the paper correctly and did not force the paper into the
When I insert the All-In-One software CD, nothing happens
From the Desktop,
All-In-One is not communicating with the computer
1Disconnect and reconnect both ends of the USB cable. For help, refer to the setup documentation.
2Unplug the power cord from the electrical wall outlet, plug it back in, and then press Power. For more information, refer to the setup documentation.
3Restart the computer. If the problem continues, remove and then reinstall the software. For more information, see page 16.
Installation appears incomplete
The software may not be installed properly. Try the following:
1
For Windows XP, click Start to access the My computer icon.
2Click Properties.
3For Windows 98 or Windows Me, click the Device Manager tab.
For Windows 2000 or Windows XP, select the Hardware tab, and then click the Device Manager button.
4Look for the Other Devices category. If there are any Lexmark devices shown here, highlight them and, then press the Delete key.
Note: The Other Devices category appears only when unknown devices are present. Do not delete any Lexmark items unless they are present under the Other Devices category.
5Insert the CD, and install the software again. Do not restart the computer. For help, refer to the setup documentation.
Printing troubleshooting
All-In-One prints slowly
1Close all programs not in use. The memory resources may be low.
2Make sure the Print Properties Quality/Speed setting is set on Normal or Quick Print. For more information, see page 7.
3Try printing a smaller file. If the memory resources are too low, you may not be able to print larger files. Consider purchasing more memory.
Note: Photographs typically have a larger file size. Try lowering the scanning resolution.
Print is too dark or smudged
1Remove the paper as it exits. Let the ink dry before handling.
2Adjust the Quality/Speed setting in Print Properties or in the
The Better or Best Quality/Speed setting may cause smearing if used with plain paper. Try using Normal.
3Open the Lexmark Solution Center (see page 8).
4From the Maintenance tab, click Clean to fix horizontal streaks.
Vertical lines are jagged or edges are not smooth
1Adjust the Quality/Speed setting in Print Properties. For help, see page 7. For best print quality, select Better or Best.
2Align the print cartridges. To align the print cartridges: a Open the Lexmark Solution Center (see page 8).
b From the Maintenance tab, click Align to fix blurry edges.
White lines appear in graphics or solid black areas
Clean the print cartridge nozzles. Going long periods without using the
1Open the Lexmark Solution Center (see page 8).
2From the Maintenance tab, click Clean to fix horizontal streaks.
E n g l i s h
15