Fluke 807-0115 manual 4xT1/E1 inline probe ASE, T h L i n k S a f e c a p a b i l i t i e s

Page 1

Visual UpTime Select

ASE model 807-0115

4xT1/E1 inline probe ASE

W i t h L i n k S a f e c a p a b i l i t i e s

Key features

•Four management ports

•MLPPP support on IP Transport software

•Inband management capability

•LinkSafe technology

•Power loss detection

•Service Level Agreement (SLA) metrics

•Application analysis capability

•LMI spoofing

•LAN management port

•Realtime events

The Visual UpTime® Select™ 4xT1/E1 inline probe ASE enhances the data analysis functionality of the Visual UpTime Select system for enterprises with two-to-four T1 or E1 circuits terminating at a single location. The ASE provides up to 6.176 Mbps (T-standard) or 8.192 Mbps (E-standard) of detailed network traffic analysis and management, while maintaining full wire speed pass-through of all traffic. In its initial release, the ASE supports IP Transport software over MultiLink Point-to-Point Protocol (MLPPP) T1 links.

The 4xT1/E1 ASE includes LinkSafe™ technology to protect circuit integrity in case of a power outage and it also delivers a notification alarm if there is a power failure.

Designed for locations with multiple circuits terminating at a single device, the 4xT1/E1 is typi- cally deployed as an inline probe between the service provider’s edge device and the customer’s termination equipment. The figure below highlights the multilink deployment for the 4xT1/E1 ASE.

4xT1/E1 inline probe model 807-0115 front

4xT1/E1 inline probe model model 807-0115 rear

Optional LAN Connection

Bundled

T1 Line

WAN

4xT1/E1 inline ASE

CPE Router

LAN

4xT1/E1 inline probe model 807-0115 position on network

Technical Data

Page 1 Page 2
Image 1
Page 1 Page 2
Contents T h L i n k S a f e c a p a b i l i t i e s 4xT1/E1 inline probe ASEEnvironment 4xT1/E1 inline probe ASE specifcationsPorts InterfaceT1/E1 inline probe ASE T1/E1 inline probe ASE specifcations Ethernet inline probe model 807-0120 front view 10/100 Ethernet inline ASE LEGeneral Ethernt inline probe ASE specifcationsLAN and WAN Ethernet InterfaceEthernet inline probe model 807-0122 front view 10/100 Ethernet inline ASEEthernet inline probe model model 807-0122 rear view 10/100/1000 Ethernet ASE With Span mode capabilitiesBit Rate 10/100/1000 Mbps WAN Hssi inline probe ASEHssi Interface Hssi inline probe ASE specifcationsSerial Port Interface CSU/DSU Inline probe ASEUser Interface Inline probe ASE specifcationsNetwork WAN Interface DTE Connector Female 15-pin X.21 connector SignalingDS3 inline probe ASE Network Interface DS3 inline probe ASE specifcationsE3 inline probe ASE E3 inline probe ASE specifcations OC-3c/STM-1 inline probe ASE HEC OC-3c inline probe ASE specifcationsOC-3c inline probe model 203 on ATM/Frame network Connector Pin modular jack RJ-48 T1 CSU/DSU ASE Data Port T1 CSU/DSU ASE specifcationsDSX-1 Interface T1 CSU/DSU model 807-0110 position on network What are ASEs? T h M o d e m Modem T h D S X 1 , D r o p a n d I n s e r t , a n d M o d e m Compliance in US and Canada Dual-port Dual-analysis ASE Power loss detection Realtime eventsWhat are ASEs?
Top Page Image Contents