CONTROL FEATURES (continued)
How to Set Optional Programmable Engine Exerciser (part of Acc. 11BG module)
Hazardous voltage capable of causing shock, burns, or death is used in this transfer switch. Deenergize both Normal & Emergency power sources before programming the exerciser.
Navigating the Menu
Use the UP and DOWN arrow | Fast/Slow Adjust |
| |
keys to move through the displays. |
|
NOTE: When choosing
Run Time Display
The Run Time Display shows the run time for the engine exerciser. The default setting from the factory is 30 min.
Time Display
The Time Display shows the present system time. The format is “hours:minutes:seconds”.
Changing the Parameters
Use the UP and DOWN arrow keys to move though the displays to the parameter to be changed. Push the ENTER key to start the editing process. The first parameter will flash. Use the UP and DOWN arrow keys to adjust the parameter to the desired value and press the ENTER key to save the value. The next parameter will now flash. Repeat the process until each parameter is properly configured.
Engine Exerciser Display
Daylight Saving
Time Adjust
Date
Time
Run TIme
Start TIme
Engine Exerciser
NOTE: During total power outages, power to the accessory is maintained by a battery in the Controller (see page
Date Display
The Date Display shows the present system date. The format is “day of week (week) month/day of month/year”.
NOTE: Week is either week 1 or week 2. This is used in conjunction with the
Daylight Savings Time Adjust Display
This display shows whether the automatic daylight saving time adjustment is active. The factory default is “NO”. If enabled, the unit will automatically adjust for daylight saving time at 2 AM on Sunday as follows:
The Engine Exerciser Display shows the status of the engine
exerciser. When the unit is shipped from the factory the programmable engine exerciser is “Disabled” and must be set to “Enabled” by the customer. When the engine exerciser is running, this display will count down the remaining time until the end of the exercise period.
Start Time Display
The Start Time Display shows the engine exerciser start time. There are four parameters that determine the start time:
weekly (”Every”) or
day of week (”Sun” through “Sat”)
start hour (0 through 23)
start minutes (0 through 59)
For example, if the user wants the exerciser to run every other Saturday at 3 PM, the proper configuration would be: “Alt Sat @ 15:00”
Part No. | ||
Start | first Sunday in April | 2nd Sunday in March |
Stop | last Sunday in Oct | first Sunday in Nov |
* Part no. on back of circuit board. New DST starts in 2007.
Fast / Slow Adjust Display
This display shows the automatic fast/slow adjustment value. The factory default is 0. This feature can be used to trim a clock that runs fast or slow. For example, if your clock runs 10 seconds slow per week, change the fast/slow adjust value to “+10” and the unit will automatically add 10 seconds to the clock every week.
NOTE: Adjustments are made Sunday morning at 2 AM. If you want your exerciser period to start at 2 AM on Sunday, you cannot use this feature and the adjustment must be set to 0.
Fill in your settings for future reference
Weekly or | Day of Week |
| Start Time | Run Time |
Every = weekly | Sun through Sat |
| 0 – 23 hour | 0 – 23 hour |
| 0 – 59 minute | |||
Alt = |
| 0 – 59 minute | ||
|
| 30 min. is default setting | ||
|
|
|
| |
|
|
|
| |
Date exerciser was set ______________________________________ | ||||
|
|
| ||