Philips WAS7500 manual 3Type ipconfig/all, Set DNS, Set Gateway, Set proxy, Settings will change

The following steps show how to get DNS and Gateway settings of the current network from the PC connected to the same network:

1On your PC, click Start > Run

2Type cmd and click OK

3Type ipconfig/all

4Write down the DNS and Gateway of the current connection.

On

1Press MENU to enter the menu screen.

2Use 3 or 4 and 2 to enter Settings followed by Network, then Wired.

3Press 2 to continue.

Set DNS

1Enter the DNS server you wrote down.

2Press OK to confirm.

3Press OK to skip Set DNS2.

Tip

If necessary, follow Steps 1 and 2 above to set a secondary DNS server in Set DNS2.

Set Gateway

1Enter the Gateway you wrote down.

2Press OK to confirm.

Set proxy

1If you are using a proxy server to visit websites, enable Proxy and proceed with the proxy setting as prompted, then press OK to confirm Otherwise, press OK to skip.

2Choose to apply the settings as prompted.

>Settings will change.

Connection to station could be lost appears.

74 Network settings