Philips WAS7500, WACS7500 Problem, Solution, Wi-Filink between, Connect to your PC and the WADM

Problem				Solution
I get interference on my wireless				• If you are playing the set, stop playback and take the
(Wi-Fi) link between		and	.		appropriate measures as follows:
The WACS7500 operates in the 2.4GHz
radio frequency spectrum. Many other				•	Keep	or	at least 3 meters away from such
household/IT devices also operate in this					devices.
frequency spectrum, for example:
microwave ovens, Dect phones, bluetooth				•	Use the WEP/WPA key when connecting						and
devices like bluetooth headphones,					to an existing wireless PC network.To set
computer mouses, wireless routers,					WEP/WPA key, connect			/		to your PC using
cordless phones,Wi-Fi compatible					Philips Wireless Audio Device Manager (WADM) in
printers, PDAs.These devices can					the supplied PC Suite CD. In the WADM device
interfere with the Wi-Fi link between					configuration, enter the Wireless Network submenu,
and	, resulting in interference such as				and in Device Wireless Authentication Type, select
pause during playback, slow response to					WEP or WPA.
my operation, etc.The severity of
interference varies depending on the				•	Change operating channel of				and		when
extent of radiation from the device and					connecting them to an existing wireless PC network.
the strength of Wi-Fi signals in that					To change channels, connect				/	to your PC
position.					using Philips Wireless Audio Device Manager
					(WADM) in the supplied PC Suite CD. In the
					WADM Device configuration, enter the SSID of your
					Wireless Network, and select ad-hoc mode. See the
					section 12 Connect to your PC and the WADM
					help file.

•If possible, change the operating channels of the other Wi-Fi devices in your home.

•Turn the devices in different directions to minimize interference.

Stations react when you operate the •		The remote control for		is powerful enough to
remote control of	.	operate several	within a certain distance or
		angle. Check that you have placed			in different
		rooms or place them at different angles.

•Use the remote control for or the controls on the set.

‘x’ flashes on the synchronous	Signal error. Check that you have pointed the remote
display of the remote control of	. control towards the IR sensor of the set you wish to
	operate.

86 Frequently asked questions